F14 fault. What do I do? - Dishwashers

You can take help from - https://realappliancerepair.com/

The F14 Fault is a heater pressure switch fault - usually a machine that that been in service for a while gets soap build up in and around the sensors - the heater pressure switch being one of those. Its purpose is to measure the pressure of the recirc pump to make sure there is sufficient water pressure to turn the heater on - without sufficient water pressure the heater would burn up. The pressure switch gets gummed up with soap deposits over time and should be changed out

Hey friend, thanks for your post!
I see that your Electrolux wall oven is displaying an "F14" error code. "F14" stands for display tail missing, which means you could have an issue within your main control board or keypad. I would perform a reset on your appliance which can be done by flipping your household circuit breaker off for roughly ten minutes. If that does not correct the issue I would suggest seeking a professional to come out properly diagnose and repair your appliance. I hope this is helpful. -Matt

Good Afternoon James,

I understand your Frigidaire range, model#GLES389EQA, is receiving an F14 fault code and you want to know what it means. The F14 fault code means there is a miscommunication between the display board and the touch panel. I suggest resetting your appliance, by shutting the power of at your home's circuit breaker, for 3-5 minutes. Once power is restored, you will need to set the clock before moving forward. Once the clock is set start the cycle that gave you the F14 code. I ask that you please follow up with a comment on the post, at your convenience, to advise if further troubleshooting is needed or if your air conditioner status has changed successfully. Hope this is helpful.

-Best Regards-
WP

Hi.

F14 means that control board does not sense that machine is heating:

F14 - A fault with the water heating has occurred

When you get F14 the fault is usually either the thermistor or the heating element (electric dryer). Both parts are tested removing the part from the dryer and reading impedance at the part contact. If the part returns infinity, then the part is defective. If you need to contact a qualified technician use the phone number listed on your owners manual or check Hotpoint website.

Regards.

Ginko

Hi

F14 means a fault on the heater pressure switch or the water intake.

It could be that either the switch is faulty or circulation pump is blocked, you can check if the pump filter is blocked

F14 = EEPROM Error

The Central Control Unit (CCU) receives it's data from an EEPROM on board the CCU.
If there is an error reading this data, it will cause this error.

A power glitch may cause this error. Try unplugging the Unit for two minutes to see if that fixes the error.
Check CCU

So its likely you'll need a new CCU board. Check your owners manual, some models have up to a 5 yr. parts warranty on that CCU.

Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question

F14 on your model of dishwasher is indicating a blockage, poor water pressure or could be a fault with the pump pressure level switch or circulation pump.

Filter and non return valve is cleaned of any blockages and if the fault persists have it service..

hope this help.

Check the motor circulation impeller, if you not maintain the unit is gonna be clog by impeller. it need to be clean.