Question about InFocus Proxima UltraLight X350 Multimedia Projector

1 Answer

Proxima Ultralight Projector 350x

My projector keeps overheating. I just attached it to my wall. Any suggestions as to why this is happening?

Posted by Premmie on

Ad

1 Answer

Anonymous

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 34 Answers

The filters probably need cleaning. Also check and make sure none of the vents are being blocked.

Posted on Dec 05, 2007

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My Mitsubishi HC3000 keeps blowing bulbs, they won't last a week now? Any suggestions?


That would be what ever they are using for a bridge rectifier most likely or cheap replacement lamps or overheating do to environment or ...

Oct 22, 2013 | Mitsubishi HC3000U Multimedia Projector

1 Answer

When using the LCD TLP711U projector for a short time it turns itself off and will no start even after pressing the on button. After waiting a while, turning off power am able to turn it on. This keeps...


It sounds like you have an overheating issue, Look through the vent slots and see if you can see a build up of dust. If you can then you will need to open the projector to clean it properly. You could try blowing it out with a compressor but be sure to use one with a water trap to stop moisture getting into the projector. You can buy cans of compressed air from electronics stores if a compressor is not available. Some models of toshiba also have issues with the temperature sensors, They are attached to the metal heatsink and the plugs that attach them to the circuit board can loosen which makes the projector think it has overheated.
Hope this helps

Oct 25, 2010 | Toshiba LCD20 20.1 in. LCD TV

1 Answer

Sanyo PLV 60 HT keeps on overheating even after I cleaned the


hi dear plz check the projectors fan. It is working properly or not

Jan 31, 2010 | Sanyo PLV 60HT Multimedia Projector

1 Answer

LCD Ceiling-mounted projector keeps overheating.


canned air from the outside is good, but a lot of the dust collects on surfaces and bakes on. for best results, remove the top cover and blothe dust out of every nook and cranny, wipe it off of the fan blades, and make sure all of the fans spin well. you may need to replace the temp sensors if it happens too frequently. also, during the winter when the heat is on full blast, it tends to get very hot on the ceilings. is there enough air flow in the room? lastly, make sure they turn them off at the end of the school day. this will lenghten the life of the power supply and the lamp.

Jan 25, 2010 | InFocus IN24 Multimedia Projector

2 Answers

After a short period of time the overheating light comes on and the bulb turns off. There's no apparent air blockage. Any suggestions?


blow any dust out of the projector with canned air. the dust keeps in the heat that the projector is trying to expell. also check the fans.

Dec 22, 2009 | Sharp XR-30X Projector

1 Answer

My NEC VT660K wont power up.


Hello.

Some suggestions from NEC support:

Check that the power cable is plugged in and that the power button on the projector cabinet or the remote control is on.
• Ensure that the lamp cover or lamp housing is installed correctly.
• Check to see if the projector has overheated or the lamp has reached the end of its usable life. If there is insufficient ventilation around the projector or if the room where you’re presenting is particularly warm, move the projector to a cooler location.

Hope this helps.

Nov 05, 2009 | NEC VT660K Multimedia Projector

1 Answer

My toshiba projector keeps shutting off after 15 min ?


clean out the projector with canned air. if it still happens, you'll need to replace the power supply.

Jun 19, 2009 | Toshiba TLP-XD2000U Mobile Projector

2 Answers

Our Eiki LC-986 projector has worked flawlessly for at least 3 years. Last week, the projector shut itself down after approximately 30 minutes of use. This happened at least 5 times, so we replaced the...


It sounds like it is overheating. Are the fans all working? If so, try opening the casing and blowing all the dust out with a can of air from Staples/Office Depot. If the fans aren't working you may need to replace them.

Jun 15, 2009 | Eiki LC X986 Multimedia Projector

1 Answer

Overheating?


Hi, you could use a high feet product from www.pwx.cc to keep the air going under the projector. some fan are place underneath which is not the best solution. 

Sep 19, 2008 | Mitsubishi SL1U Multimedia Projector

1 Answer

Warning lamp glow


Hi

Does your projector still work?

The warning lamp is there to let you know there is a problem, usually overheating! Make sure it is well ventilated and that the filters have been cleaned.

Try disconnecting the AC power cord and then reconnect it to check if it is still happening.

Oct 05, 2007 | Sanyo PLC XU50 Multimedia Projector

Not finding what you are looking for?
InFocus Proxima UltraLight X350 Multimedia Projector Logo

Related Topics:

304 people viewed this question

Ask a Question

Usually answered in minutes!

Top InFocus Office Equipment & Supplies Experts

jasbo
jasbo

Level 3 Expert

2239 Answers

Ekse

Level 3 Expert

13434 Answers

martin hogg

Level 2 Expert

157 Answers

Are you an InFocus Office Equipment and Supply Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...