- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Realistic radio mics are all , except for a few , wired the same. All you have to do is look up the wiring for the realistic 5 pin din plug . One of those wires in the mic is not going to be used the thing is which one . Connect the wires as they are mentioned in the diagram then if it doesn't work connect the last wire.
I don't know which mic you're trying to wire to this radio. The colors of the wires in the mic cable may change from one mic to another, so relying on the color is not reliable. Usually you refer to these connections as Pin1 to a Signal or Function; or Jack Pin1 to Plug Pin3. No one assumes a color will always be used to connect Pin1 to TX (transmit).
With that said, I found an answer on FixYa from someone that answered the question some time ago like this:
HERE IT IS THE CORRECT MIC WIRING FOR THE REALISTIC TRC 447.
4.)CH.Down / Shorted to Ground
6.)Ch.Up / Shorted to Pin 4
Be extremely careful when wiring this radio! pin 4 and pin 6
carry voltage shorting these to the wrong place can result in serious
damage to your radio.
Lastly, since I doubt what was provided above is going to help you very much - you can review all the info ever printed by Realistic on your radio, here. There's a wealth of info on this page and you should be able to find what you're looking for in it. You're looking to find the pinouts of the radio to the pinouts of the mic.
If you ever have to disconnect a multiconductor cable from a connector, and you don't have the time or means to write the colors down, it is better to simply cut the cable - leaving all the colored insulation of wire ends soldered / still secured to the connector. When you are ready to do the replacement of the connector or cable, you've got the wiring order in place still, and can make the new connections one at a time at your leisure.
please help, I'm trying to wire a Cobra Mic to a 40 channel President Teddy R.
Hi, please help me with wiring my Cobra Mic to my 40 channel C.B. President Teddy R. The colors of the Mic wires are : Red, White, Black, Ground[bare]. Thank You and Have a Good Day.
my switched power wire for stereo has no power. wanted to just run a new one strait from ignition to head unit... what color wire wouuld i splice into? And where is easiest access? any pictures would be a tremendous help