Galaxy 66v no key up or modulate - Galaxy Radio Communications

This involves checking the voltages on the internal final and driver transistors. The base connection should have 4 to 6 volts on it..

Go to www.cbtricks.com they have all the info you need

vr 14

could be a number of reasons but the one I think of is a capacitor on its way out. check for leaking electrilytic caps . Could also be diodes or transistors ,even resistors .

gal 66 check the 10kHz switch. or you may have a bad cap, or crystal,.. the 33hp2 check the am regulator transistor... is bad or shorted.

The Galaxy DX-66V is worth between $270 and $300 new. If I were to have one on the shelf for sell at my shop, I would price it at $285. That would be already converted and peaked and tuned, ready to talk.

I hope this helps you out. If you have any additional questions, you can shoot me a pm at [email protected]

Dean
Rollin CBs
[email protected]

I have found bad cabling and bad grounds on this and the other board in the freq counter can.

Cold solder joints are a known bugaboo with these radios......

rather than use a small linier you decided to break your radio instead . It still sounds like a cold solder point to me .

as far as the transmit frequency changing while you have the mic keyed this is normal, the transmit frequency is a little different than the receive, as far as the lost channels go you need to check the galaxy website and check to see if thier is any fixes listed. if none is listed then you can send the tech's a e-mail and tell them your problem and they will advise you on what to do.