Inner tray is full

The SYS board for
e-STUDIO2050C/2550C/2051C/2551C
Is installed in
e-STUDIO2055C/2555C/3555C/
4555C/5055C.
Or the opposite combination.

Hello
Are you looking for help about this get connected with us on 1-877-778-89-69.
Toshiba Tech Support Advantages And Features

my dear you chek senser and clean

http://servicemanuals.pro/servicemanuals/panasonic/home_appliance/nn-2505a_nn-2505c_nn-2555a_nn-2555c-7059/download.html?Itemid=0

Make sure that the inner tray that the paper rests on moves through its whole range of motion. The most common problem I have run into, is that on the left hand side of the tray, where the paper level indicator is located, there is a C shaped piece of plastic that is supposed to be on both sides of the metal tray becomes dislodged and sits either on top or on the bottom of the tray and blocks the tray from moving through the full range. You will just have to jimmy it back into position.

if this were your problem it would be obvious the inner tray is in the middle of the machine there is a lever that lifts up as paper stacks up its probably stuck in raised position

Try removing the paper from the inner tray....

the inner tray is where the paper comes out under the top scanner part there is a paper sensor at the exit mark that tells you if you have paper in the tray and lets the machine know it has come out ok. check that it hasnt locked in place.. this can give a false reading too..Good luck

unfortunately that is not possible

Technican came in