Help to reasemble a electro dot sight a parts list might help ?

Check ebay dot com as they are now allowing rifle parts to be sold.

Normally most pull starts have a pre-wound spring (in this case a long piece of flat metal) that is housed in a round spool that has "fingers" that prevent the spool from spinning backwards. These "fingers" also catch the outside cylinder and deliver your pulling energy to the device. Your question appears under "washing machines." I'm guessing you do not have a pull start on a washing machine. Please list the type of device you are sealing help with.

Yes they are made to withstand large caliber pistols and rifles, with way more static shock. Hope this helps Fix Ya up.

The top yoke of a Manfrotto 190PROB is held in place by a spring mechanism. The spring mechanism is just behind the screw that tightens the center column. First remove the center collumn. Inside the to yoke (where the centre column was) there is a small hole. Poke something in that hole to push back the spring mechanism. You should now be able to push the yoke out towards the top. When the yoke is removed you will see the three screws that keep the hinges tight. Reasembly is straight forward. Simply re-enter the yoke in such a was as to push back the spring mechanism.

www appliance parts

There are three supports that if not on your machine will cause it to make loud noise and shake due to the outer tub riding on metal on metal. These are located on all three straight frame bars. Look at this sight and you will see the parts I'm referring to.
http://www.partselect.com/PartDetail.aspx?Inventory=334620&SourceCode=6

If these are bad or they are gone, replace them and your problem will be solved.
Please rate solution. Thanks

I'm not absolutely positive, but the pieces you speak of sound like a cushionbetween the lever and cylinder.---- Piece,-spring-Piece------ It acts as a cushion and assure clutch cylinder is actuated with
enven and aligned thravel so the pisto is not subjected to side pressures of the lever movement. Good luck and happy trails. They wou;d fit between the lever and cylinder like a flexible push rod.

that is the problem with red dot sights.if your eye sight is not 20-20,you will get a star burst or halo.glasses will help.