Location of reset fuel switch for 2002 Jeep Liberty Sport

no idea to be honest earlier jeeps had then at the front of the wing down below as i remember ?? newer one would i imagine be in the electrical box under the bonnet near the battery

Have you tried to jump started ? If your jeep starts when giving it a jump, you may have a bad battery. Check fuses for fuel and ignition systems. If your battery is bad, could be because the alternator is not charging it. Might want to have this component tested.

Bleed screw, jeep liberty limited, 2002, 3.7 L, no heat - Fixya

www.fixya.com/cars/t14960103-bleed_screw_jeep_liberty_limited_2002

Nov 10, 2012 - bleed screw, jeep liberty limited, 2002, 3.7 L, no heat - Jeep Cars & Trucks question. ... Open Question ... Feel radiator and heater hoses, should be very warm to touch,if hoses ... Where is the location of the slave cylinder in a Jeep Liberty2005 ... Bleeding air out of a 2003 jeep liberty sport with a 3.7 motor.

Jeep Liberty - YouTube

? 7:17
https://www.youtube.com/watch?v=Nv0HpH2ymB4
Jan 24, 2014 - Uploaded by 1A Auto Parts
http://www.1aauto.com/1A/ThermostatHousingRel/Jeep/Liberty/ ... What no engine heater install 2007 3.8 j wrangler video ....When opening up the bleeder valve, do you just keep it crackedopen until you have no air bubbles ... already replacing the water pump at 138,000 on an '05 Liberty Limited 3.7L..

Jeep Liberty heater not blowing hot air Questions & Answers ...

www.fixya.com > ... > heater not blowing hot air > Cars & Trucks > Jeep

Jeep Liberty cars & trucks heater not blowing hot air questions and answers. Ask your Jeep heater ... My 2005 Jeep Liberty will not blow heat through ... properly.

jeep liberty 2002 heat problem/hvac box issue - YouTube

? 3:12
https://www.youtube.com/watch?v=xf22fvcN1hU
May 28, 2013 - Uploaded by Joffre richer-desroches
Joffre richer-desroches. ... How To Install Replace Engine Coolant Thermostat and Housing 3.7L 2002 ...

http://www.bing.com/videos/search?q=heater+core+hoses+on+a+2002+jeep+liberty+sport%3f&FORM=HDRSC3

http://www.bing.com/videos/search?q=heater+core+hoses+on+a+2002+jeep+liberty+sport%3f&FORM=HDRSC3

For a temperary fix, you can remove the flasher. Makesure it is the one to the flashers and not the turn signals. Probably need to replace the multi-switch in the steering column.

timeing chain

These are common for the instument clusters to go bad. There are places that can rebuild it or you may have to replace it all together. There is a self test you can run by: key off, push and hold odometer/trip button and then turn the key on while holding the button *don't start it though*, then release the button and it will automatically start the self test. It will show a series of digits and then the software version #. After 5 beep tones it will automatically exit the self test mode. During the test, you can observe the speedo and fuel gauges to see if they are working.

Disconnect the negative battery cable at battery.
Drain coolant from radiator
Remove the front grill .
Remove the cooling fan from the engine, if equipped.
Remove the two radiator mounting bolts.
Disconnect both transmission cooler lines from radiator.
Disconnect the connector for the electric fan.
Disconnect the power steering cooler line from cooler.
Disconnect the radiator upper and lower hoses.
Disconnect the overflow hose from radiator.
The lower part of radiator is equipped with two alignment dowel pins. They are located on the bottom of radiator tank and fit into rubber grommets. These rubber grommets are pressed into the radiator lower crossmember.

The thermostat is located in the metal housing at the end of the top radiator hose where it connects to the engine mainifold.
The hose is held onto the thermostat housing by a clamp.
The thermostat housing is bolted to the manifold with two bolts.