Loader throws codes then dies
Hi heres a full list of what you need to help you.please see link and scroll down the page...
https://www.truck-manuals.net/bobcat-fault-codes/
SOURCE: How do you bleed the hydraulics on a Bobcat 751 skid steer loader?
Hi Joseph:
Usually hydraulic components will "self clear" any air in the system just by trying to cycle through the functions a few times.
Have to ask the question............
Did you remove and replace the hoses one at a time, or did you take them all off at the same time?
The reason I ask is............ Could there be a remote possibility that any of the hose onnection locations were switched?
Testimonial: "I did remove three of the hoses at one time simply two of the hoses were rubbed through and to remove one of the ones I had to remove another to get at one rubbed through. However I am 100% sure they are installed correctly because only two of the hoses are the same diameter and they run parallel to each other and one has to be installed before you can install the other. Thank you for your help. I see I need to get more hydraulic fluid as my level went down after trying system. Joe"
10,852 views
Usually answered in minutes!
did you ever find out the problem with your bobcat ours is doing the same thing
bad fuel, change fuel filter then runs fine. later we found a factory recal on the injector pump and the rest of the fuel system. they didnt flush the pump, lines, rails and injectors before they sent them off the line. we caught it in time and was no cost to us
Si what the problem was. The fuel pump??
Hi guys. I have a 2016 bobcat t740.
Have a hard start only at first start of the day after that start at first try, also when workin at full throttle and pushing dirt it will die and show 1076-16 code but will start back up no problem
×