Miracle Business Elite Miracle One Residential Swing Gate + Two 371lm Logo

Related Topics:

A
Anonymous Posted on Aug 10, 2016

Hello. I'm having an issue with an Elite Miracle two gate operator system.

The issue i am having is that both gate operators open properly. After the time delay finishes only the master operator closes . The slave operator will close after 30 or so seconds. This poses an issue because I have a mag lock installed which requires the slave operator to close first. Both the main PC board and Surge board have been replaced but problem still exists. I've checked limit switches on both operators and they ohm out correctly. Any assistance would be appreciated. Thanks

1 Answer

Clinton Daley

Level 2:

An expert who has achieved level 2 by getting 100 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Sergeant:

An expert that has over 500 points.

  • Expert 238 Answers
  • Posted on Aug 27, 2016
Clinton Daley
Expert
Level 2:

An expert who has achieved level 2 by getting 100 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Sergeant:

An expert that has over 500 points.

Joined: Aug 26, 2016
Answers
238
Questions
0
Helped
96665
Points
617

Swop the board around

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Elite gate won't open

this system runs of of the batteries and the system is constantly charging the batteries but if the batteries go bad it will act up even if the incoming power is good.

power it down unplug the batteries and use your multi-meter to see if you have good batteries.
0helpful
1answer

Eagle slave gate not opening with master

Switch leads for master and slave to see if its a wiring issue. if the same gate fails to operate, it may not be your controller.
1helpful
2answers

Miracle one gate opener not working. Was work fine and lately not opening all the time. Now not at all. Looked and all fuses they are ok. System on light is off. only ligts on in control box are the...

Have you checked the fuses? They are small and can be difficult to see because of the thin wires. Check those first, especially the motor fuse on the lower left corner of the board.

Does you system use a wireless remote or keypad, or to open/close.
0helpful
2answers

I have a Miracle One gate opener and, as I've done a hundred times previously without incident, I clicked remote to leave gate partially open (to take trash cans out), about 20 seconds later, the gate then...

The memory could have been somehow corrupted. I would suggest that you call in an experienced person to reset and reprogram the open/close positions.
Hope this helps :)
1helpful
1answer

Where is the programming button to add a Homelink equipped car?

Follow the instructions on homelink's website for programming a garage door opener with a learn button. The learn button on the miracle one is inside the control box. After you remove the cover, you'll see the radio receiver on the left side near the bottom of the control box. The learn button is near the front edge of the receiver.
0helpful
2answers

Someone please let me know whether the red and brown leads from the swing arm on an Elite Miracle One should be shorted. Please attach a multimeter to a the red and brown brake leads coming from the swing...

Hello,

The red and brown LEDs from the swing arms on the elite miracle one should not be shorted.

There was no continuity after a multimeter was attached to the red and brown LEDs coming from the swing arm.

The LEDs carry the function of indicating the input and output function and shorting them actually brought about no continuity.

I hope this piece of information would be helpful to you/

Take care
0helpful
2answers

The outgoing gate has a positive stop on it, but

Well it seems that their could be a limit switch problem. also if someone has replaced the limit switch they could have not connected the wires back up correctly. if your wiring and switch are correct than you have a bad circuit board. my opinion is to not even fix it and replace the whole opener with a gto-pto gp sl50 They are the most reliable opener out so far and come with all the features that elite charges extra for like a battery backup for instance.
0helpful
1answer

Holiday Programming

the elite does not have that function, your are going to need to look for a time clock that holds open your gate...... the outside phone system or a programmable time clock that has been added to your gate...... oh this is an old post sorry. :)
Not finding what you are looking for?

380 views

Ask a Question

Usually answered in minutes!

Top Miracle Business Home Security Experts

Brad Brown

Level 3 Expert

19187 Answers

ADMIN Eric
ADMIN Eric

Level 3 Expert

39362 Answers

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

66831 Answers

Are you a Miracle Business Home Security Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...