I have a Tappan double oven Model 11-4361-30. I am trying to replace it, and I can't figure out what size modern oven will fit.

Nothing exists online for that. You remove it from the cabinet and measure the gap width and height. Then put the rule in to the back and measure to the edge lip. Take 6" off that measurement for an air gap.

https://www.google.com/search?q=Tappan+Double+Wall+Oven+11-2969-10-01+dimensions

..

BUY A TAPE MEASURE AND FIND OUT WHAT THE SIZE IS

Hello, Diana -

You MAY be able to find the replacement gasket here:
https://www.searspartsdirect.com/partsdirect/brands-products/Tappan-Parts/Range-Parts
or here:
https://www.partselect.com/Tappan-Oven-Parts.htm
or here:
https://www.ereplacementparts.com/tappan-oven-parts-c-442308_442314.html

You will have to do the searching as each web site requires the model number or part number to determine if what you seek is in stock.

Best wishes.

try RepairClinic.com they may have the parts and delivery has been good for me.

these are NLA. No Longer Available.
Try to get something that is acceptable to you and fits by researching "oven Knobs" at repair clinic dot com and selecting by looks and size.

You plobably have the incorrect drip pans that do not have the proper holes for the grates to fit in, I would chech with an appliance repairman, he should have a source for the correct drip pans.

Most of the installation manuals for GE appliances are available on their support page: http://www.geappliances.com/ge/service-and-support/literature.htm . I found several double wall oven models with the JKP27 designation. However, the G0J4BG does not fit as part of the model number. There should be 4 letters after JKP27 in the model number. These letters primarily indicate the color of the exterior. For the JKP27 models, the installation manual says that the cut-out should be 32 1/2" above the floor. The depth has to be 23 1/2". The cutout width should be between 25" and 25 1/4" (these are an absolute minimum and maximum). The cutout height should be between 27 5/8" and 28 1/8".

The direct link to installation manual for one of these ovens is here: http://products.geappliances.com/MarketingObjectRetrieval/Dispatcher?RequestType=PDF&Name=003675840.PDF . See page 6 for the cut-out dimensions.

I hope this helps.

Cindy Wells

Try the partstore at
http://www.partstore.com/Search/Model/Electrolux/Tappan.aspx#
they carry Tappan oven parts.

I have an O'Keefe & Merritt double oven gas stove. The model number is 72 7242 23. The upper oven is about the size of a large microwave and sits above the range burners. The lower (full-size) oven is below the burner unit and includes a broiler draw below it.
So, when you say, double oven, I wonder if you are just talking about the main oven with broiler drawer (both of which are below the burner unit.)

Mine was a builder-supplied appliance in the new house we purchased in 1986. The upper oven has never performed very well. And, yes the upper oven can only be used for baking.

I have an instruction manual for it, but it doesn't provide that much information. Getting parts for it is extremely difficult, since Tappan is no longer manufacturing this brand. (I've been trying to locate a flat oven ignitor for the upper oven and can't seem to find a replacement that's the same 6-1/3" length.) In the 1980s Tappan apparently purchased O'Keefe & Merritt and marketed this brand for several years. Models originally manufactured by O'Keefe & Merritt in the 1930s-1950s are considered collectible antique stoves!

If you want to email me, I'm at [email protected]

I tried randomly pushing 2 buttons at a time, and when I pushed "Timer Off/On" and "Cancel" together it unlocked and is now working fine. The following day it beeped a lot for an hour or so (must have been catching up on previous pushes) but now is back to normal.