How to reset aiwa receiver to show dosplay - Aiwa Audio Players & Recorders

Try to RESET the receiver, here is a link to your operating manual. Go to page 23
Aiwa AV D58 User Manual

You need to hit the tape monitor button again to turn it off. If the tape monitor is on, no other audio will be output to the speakers.

Hi, I've found the problem. There was a closure in the Sorround Amlifier, and the protect circuit stopped the whole receiver. Br., csdombi

chuck05,

You might try to find a reset button on the back of the unit. Also, the Aiwa website may have a "support" staff that can see if they have an archived manual or tell you which buttons to push. Also, check to see if the unit has a fuse in back. Finally, check a website called audio.manualsonline.com . It's a free deal where people exchange manuals and information.

chrisxx

If you know basic electronics and can recognize parts inside receiver, then I'm here to help you but please don't call it as junk. Its beautiful piece of Aiwa.

Being an Aiwa service man, may I know problem in your Aiwa receiver. For your information, Sony is dealing Aiwa too because its subsidiary of Sony. You can ask Sony for Aiwa service. For details, click on Sony Official Information page. and here is Aiwa Support page.
Regards,

This Protection activates if you hook up Unmatched Speakers i.e less or over impedance as required by Aiwa Amp. 2nd reason can be extra speakers attachment.

when turning it on hold the enter key at the same time to reset the machine back to the factory settings

There could be a number of reasons causing this malfunction, try replacing the subwoofer's cord, it might be damaged, you can also try reseting the system to the factory settings according to the following instructions: Reset Instructions: 1. Press the power button to turn off the power 2. Press the power button while pressing the ENTER button. (note: this will reset all memory) Good Luck