AXILE BROKE IN HALF DO YOU HAVE INSTRUCTIONS ON HOW TO REPLACE?

You can replace the drive with any internal dvd read write drive

you mean grease,replace unit.

This iis very coomon, the part of the handle that broke is the part that releases the latch, you will need to replace the handle, the inside door panel needs to be removed to replace the handle, some of these are revited on and you will need to drill out revits from the outside and disconnect the linkage from the inside, hope this is helpful.

This is usually the agitator dogs have worn out or broke. These are very inexpensive and easy to replace. Here is a video this will walk you thru checking and replacing the agitator dogs . You can also enter your model # for diagrams and illustrations of your specific model. Not all models are available. All parts come with installation instructions.

should be only the nut at one end holding it in. the bearing bushes can freeze on the swing axle, let it soak with a good penetrating oil, and tap it with a brass mallet or drift, might need a lot of hits, try not to damage thread

Usally if your turning the wheel and accelerating the axles will make a clicking noise if the joints have gone bad. If this is the case then you need to replace the whole axle(s)

check cv boot for rip or damage

YOU WAS TOLD RIGHT U NEED TO REPLACE THE OUTPUT SHAFT SEAL WHERE THE AXILE SPLINE GOES INTO THE TRANSMISSION.EASY FIX

no. It would be the other way around. If something went wrong in the rear end and it locked up, you could break the drive shaft universal joints trying to force it to go. if your rear end locked up, I'd be willing to bet there was no oil in it.

Hi
Seems like the door switch is failing, or failed.
wpecially if a front loader, the door has to be closed, and register on the circuit as closed before the machine will start.
they are cheap and easy to replace, most of the time, but cant give instructions for an unknown whirlpool other than
take front panel off
replace door switch
replace front panel