Question about Electrolux Freezers

1 Answer

Whats min f8 - Electrolux Freezers

Posted by Sabir Ansari on

Ad

1 Answer

Nater13

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Electrolux Master
  • 610 Answers

It is probably the thermistor, F8 is a thermistor error on most Frigidaire freezers... Frigidaire Freezer Thermistor 297110400

Posted on Aug 01, 2016

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Kenmore freezer model 2709 will not run for more then 2 or 3 mins


It's either a bad thermostat, or a bad compressor kicking out on overload. There are other rare possibilities. A multi meter is the best way to check the thermostat (using ohms), but if you don't have one then you can unplug the box and wire around the thermostat and the plug the box back in to see if it runs longer. If so, then unplug the box and replace the thermostat. If you are unfamiliar with wiring then call a technician. Electricity can kill you if you don't know what you're doing, so don't chance it if you don't know anything about it.

May 11, 2014 | Kenmore 12.8 cu. ft. / 362 liter Chest...

1 Answer

Have a small Kenmore freezer (31" high x 24" deep by 21" wide). It works fine as far as freezing, but it never cycles off. Just keeps on going and going, driving me crazy. I also continually hear a subdued...


the wooshing maybe the oil/freon migrating thru out the internal system...
The cycle depends on 2 things... t'stat operation and timer. The timer usually shuts off freezer every 6 or 8 hrs for 20 to 30 mins. But the t'stat (once it reaches desired temp. should shut off freezer every 15- 20 mins. for an average 10 -15. So 15 mins off min 15 mins on (that is if the doors is not open) you get my point something like that...
but the way you describe to me it sounds like the t'stat. set it at 1 if it dont shut off and you are absoultely sure you got zero degrees (use a temp. reader) then replace the t'stat

hope this was helpful
let me know if this didnt work then plan B

Mar 09, 2010 | Freezers

1 Answer

Compressor start for a few second and cut off and start again. whats wrong . berverage-air freezzer single door model no. ef24-1as


dirty condencer coils bad fan motor or compressor start relay on the side of compressor or turned off then back on without waiting 5 min.

Dec 09, 2009 | Beverage-Air Freezers

2 Answers

Small production of ice? What should be the normal production of ice?


The way I understand how Hoshizaki machines work, the model number is usually what the unit will produce, in pounds of ice. Their manual states: "Approximate production/ 24 hours @ 70 degrees air/ 50 degrees water (incoming)" So, yours should be producing 450 pounds a day, approimately. Since I can not pin point your exact model, I found one that is close. It states: "Ice Production per cycle: 6.6 pounds, 360 pcs." Again, it is not you exact machine. Their web site does not show this model either. So this is the best info I can get for you. Hope this helps.

Jun 03, 2009 | Hoshizaki Freezer Commercial Ice Machines...

1 Answer

Is Freezer Motor On The Outs?


The over current protection relay needs to be checked out. Usually it is mounted on the compressor or nearby. Unplug before attempting repair.

Aug 04, 2008 | Kenmore 13.7 cu. ft. / 388 liter Upright...

1 Answer

Ice cube cycle time very high


i suspect a defective liquid line or pump down seleonid coil. just make sure you hear the "click" when it starts up if not the selenoid coils could be defective. also verify that the condenser fan is running,because if not you are short-cycling on high head pressure. please contact if you need any additional info

Jun 11, 2008 | Hoshizaki Commercial Freezer KM-500MAH

1 Answer

Fridge Freezer in Autodefrost mode


Power surge can cause problems such as you have. I am not familiar with your brand but it sounds like the defrost timing circuit is your problem. Defrosting the surface of the back wall is not the answer. The cooling coil in the freezer is behind the back wall normally and a surface defrost does not do the trick of defrosting the coil. Have an appliance service tech check it out for you.

May 30, 2008 | Freezers

2 Answers

Aeg fault codes


aeg santo fridge/ freezer

The fridge part of my appliance is not getting cold please help

Apr 13, 2008 | AEG 10.35 cu. ft. / 293 liter Upright...

Not finding what you are looking for?
Freezers Logo

Related Topics:

214 people viewed this question

Ask a Question

Usually answered in minutes!

Top Electrolux Freezers Experts

Dennis Boxerman

Level 3 Expert

1305 Answers

washington munene

Level 1 Expert

15 Answers

ray gallant

Level 3 Expert

71004 Answers

Are you an Electrolux Freezer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...