What can i do when my printer stopping working ?

Under the lid of the scanner is a rotary knob which is responsible for ensuring thescanner stop lamp evtar damage when transporting.
Turn to release it.
If not corrected the fault you have to clean the scanner bed.

This one of the more difficult problems to locate, check display for cracked solder joints, overheated parts, open foil, or the backlight has failed.

The arm activator is wire if you raise it up it should stop making ice. It sounds as if your stop may have broke. This would cause a continuous ice flow

Follow the instructions step by step

1. Turn off printer, cable power still plug in,
2. Press Stop/Reset button don't release
3. Press Power Button don't release and than release Stop/Reset button
4. Press Stop/Reset button 2X , wait until service mode to " 0 "
5. Turn off printer, cable power still plug in
6. Press Stop/Reset button don't release
7. Press Power Button don't release and than release Stop/Reset button
8. Press Stop/Reset button 4X , wait until service mode to " 1 "
9. Turn off printer, and loose cable power, wait one minute.
10. Connect cable power, turn on printer again, now this printer ready to use.

Follow the instructions step by step

1. Turn off printer, cable power still plug in,
2. Press Stop/Reset button don't release
3. Press Power Button don't release and than release Stop/Reset button
4. Press Stop/Reset button 2X , wait until service mode to " 0 "
5. Turn off printer, cable power still plug in
6. Press Stop/Reset button don't release
7. Press Power Button don't release and than release Stop/Reset button
8. Press Stop/Reset button 4X , wait until service mode to " 1 "
9. Turn off printer, and loose cable power, wait one minute.
10. Connect cable power, turn on printer again, now this printer ready to use.

If you are satisfied, please rate or/and leave a testimonial. Thanks!

I have a remote for adjustable bed that won't work. I know it is the remote, because I put a new 9V battery in and the red light doesn't come on. Model No:R2-T3. FCC ID: MGB _R2-T (03-680252-03). I see someone posted the same problem and don't see any recommendation to fix or replace it.

Did you try the memory card on another PSP? Or try another memory card in your PSP? If your memory card works in another PSP, then there's a problem with your memory card reader.

If you have a PSP-1001 model, it's not your motherboard but the circuit board that holds the memory cards.

If you have a PSP-2001 or PSP-3001, the memory card reader is a part of the motherboard and they are correct -- bad motherboard.

Hi there
The shock from the drop may have displaced the memory modules and the video drivers could be failing, take them/it out and re-seat them/it, then try to boot the pc again. If this does not work the hard drive has took the brunt of the shock and you have to run the recovery cd or partition. I must warn you however, that you could loose data if you have to perform a recovery.
Good luck and let us know how you get on.

Why nokia 6600 is stopped from manufacturing?

Just buy new external ( HDD ini is fine) just change the external for both off you