The screen remains frozen on switching tv on - Alba LDVD1538WDCH LCD TV

you may visit some mobile sites.......

unplug it for a few minutes, see it that resets it.

It is not your tv its channal 9, switch off totally at the wall, disconnect aerial, turn on - tune into channel other than 9, plug in antenna again

You need to move further south if it is frozen. It's cold up north :-)

If you've pulled the power from this tv (power cycled it) and it still has this problem ... frozen with no picture and no sound. How a screen can be frozen with no picture, I'm not sure. But it sounds like you are going to be on your way to the repair shop. Or to buy a new tv.

If I couldn't see and couldn't hear, how would I know you were even here?

I read the manual. There is a reset button underneath the plastic cover surrounding the screen (pry off w/ your thumb) -- push the reset if the power can't be turned off otherwise.

Try pressing the reset switch on the back....

Look for a button on the remote or front of the set that is labeled input (could be tv/video) this switches between video inputs and the tuner.

Take A pencil and press the reset button.

The Palm should return to regural

Solution that worked for me:

Beware: Although the process should be safe, it technically voids your warranty.

Enter the service menu:
1 - turn of tv with remote
2 - press and release in the following order on the remote: Info, Menu, Mute. Make sure remote is pointing at the tv
3 - turn on the tv from the remote
4 - you will see the service menu. using the down arrow on the remote select the Reset option. Using the right arrow button at this point will do a hard reset.
5 - Wait a few seconds, turn TV on
6 - you will have to rescan analogue and digital channel but it should be working now.

that problem is a factory defect in the if and video section of the tv only the manufacturer could remedy that.take it to a tech so that the video board and the IF board be replaced