"BB__DataMsr.c 487T" error message.

Turn the Printer on
Wait for the error message
open the printer
move the ink cartridge a little bit to the right
on the left side you have three gear wheels
move the frontmost forward to move the printer carriage it should go easy.
Close the Printer and press OK to test the printer.
If it not works move the gear wheel further and further and maybe backwards to remove stuff which block the carriage

Make sure there is no paper even a small piece of it inside the printer. Open all doors and close, remove and replace cartridges and then power off and power on to printer! Most often its a minor problem can be corrected by these measures!

Hello
Before any expert can assist you we will need the make and the model printer. Thanks

Reinstall the OS and restore from the most recent backup you have...



Download the OS file to your PC then install it to your PC by double clicking the file you downloaded. (Vista users be sure to right click on the .exe file and select "Run As Adminstrator.")
2. Go to c:\program files\common files\research in motion\apploader and delete the vendor.xml file.
3. Plug in your BB to a usb port and double click on "Loader.exe." It's located in the same folder as the above vendor.xml file.

Don't disconnect your BB unless you get an error message, or you get a completed message. Some of the upgrade steps take a while, and it may appear to have stalled or stopped, but it has not. Be patient, and let the update load (30 - 45 minutes).

I’m happy to assist further over the phone at https://www.6ya.com/expert/joe_8b8c2cd6ce148309

Hi,At printer start, receive the following message: PRINTER ERROR 54.18. According to the HP error code message reference, this is a black cartridge sensor malfunction. Cleaned the sensor contacts, replaced the cartridge and rebooted; same error. Is there another fix for this?

Thanks for using fixya.....

Could be many things, you have to enter service mode to get the actual error, could be waste ink full, purge or feeder error, printhead failure, I would bet on waste ink full, a shop repair.

The java script version of the website likely exceeeds the Blackberry's ablity to decode it. You cannot upgrade the JS on the BB like on a computer, you need to upgrade the handheld OS to do so.

I commonly have to remind myself that my BB is no mainstream computer, it is just a smart phone and should be used as one. If you really insist, contact the website or query BB forums to see if anyone can log in.

Found this link that tells you how to reset the printer.

http://www.fixyourownprinter.com/forums/printer/39471

Excerpt on resetting the printer from the post linked to above:
These are from the link above:
Reset the system by holding down the OK, Cancel, Black, and Color buttons down at the same time and turn the 3310 off. Keep holding the buttons down until the printer shuts off and then turn it back on.

Only Solution is Re-burn printer firmware.

Mahesh DG, Pune

You need a new printhead from Kodak AiO support. After that is in and you do not have the error message anymore, download the latest firmware at www.kodak.com/go/5300downloads