A "Please Wait" is displayed on LED screen. with time but cannot operate radio

easiest way to set clock time. Remove AA battery's if installed.
Unplug Clock from AC. Wait a few seconds. Then replug clock into AC power. Clock will now flash 12:00. Press hours button until correct time is set PM has led on AM has Led off. Set minutes to correct minutes. Then press alarm reset / power/mode button. Wait a few seconds and display will show correct time. Now you can put the AA batteries back in.

Test the remote control. Use the digital camera , point the r control viewing the camera, and with the camerA ON, you must see the LED I.R ON. see the picture. If NOT you must open the remote and clean the keypads from dirty+ and resolder the cold joint from the LED.
try again. However if the LED is o.k read your owner manual download for free go www. fitness.manualsonline.com
God bless you

If the radio is not happy with the code you are entering there is a possiblity it has locked you out - Leaving the ignition on with WAIT on the screen (1 minute for 1st incorrect enter, 2min for 2nd, 4min for 3rd, 8min for 4th etc) until such time that the radio displays CODE or until leaving the ignition on doesn't remove WAIT from the screen. (possible new radio required at that point)

From the installation guide for this AP, I find the following:

LED Indicators

The unit has LED activity indicators on the front of the case provide a status display indicating error conditions, transmission, and network activity for the 802.11a (amber) radio or the 802.11b/g (green) radio.

802.11a Activity LED Amber

The amber LED flashes three times per second until firmware is loaded. During boot, 802.11a mobiles cannot associate. After adoption, the amber LED is steady or flashes with 802.11a radio traffic.

The amber LED flashes once per second if an error prevents the 802.11a radio from operating normally.

802.11b/g Activity LED Green

The green LED flashes three times per second until firmware is loaded. During boot, 802.11b/g mobiles cannot associate. After adoption, the green LED is steady or flashes with 802.11b/g radio traffic.

The green LED flashes once per second if an error prevents the 802.11b/g radio from operating normally.

From this, it appears that the 802.11A radio is malfunctioning.

Here is the Motorola support web page for this device.

If you have the correct radio code for the unit, just wait about an hour with the power on in the radio. The screen will eventually display (code) or (enter code) follow the directions in your radio manual to enter the code and the radio will be operational again. The safe mode is on because either the radio fuse blew, the battery was too low on charge or the radio was momentarilly disconnected from it's power source. Most common is low battery voltage. Charge your vehicle battery, locate the radio code, wait till radio displays CODE and enter the code an have happy tunes again.

Hello There

That normally happens when you enter the wrong code too many times. when you get the wait on the screen, that normally means you need to wait for a certain amout of time with the radio turned on and then it will come up asking for a code, each time you enter the wrong code after this will mean longer and longer wait times.


Hope this helps.

If my answer has helped you, please rayte me on Fixya.

Many Thanks

ILikeBMW

the classic cdr201 will not record it will go to wait and return to cd status(blank cd etc) there is no led display of sound during this operation you can hear the audio for brief couple of seconds before it goes back to cd mode

Depends where you are in the world, try a google search for CR 2430 as below and add your country: http://www.google.co.uk/search?hl=en&q=CR+2430&btnG=Google+Search&meta= Please update the question & let us know if the information given was useful to you - Good Luck!