Dab dewalt radio dial jumps and skips volume numbers and even turns it down when I'm trying to turn it up. It's like I turn it and it its ticking over but doin nothing

FM radio settings
Note: You can only see the FM radio settings when you have selected ‘FM’ as the radio source.
FM stereo option
You can choose between stereo or mono reception when listening to FM radio. Mono may improve
clarity where stereo signals are weak.
To change between Stereo or Mono reception:
1. Press the Menu button.
2. Turn and press the Select dial to choose ‘Audio Setting’.
3. Select between ‘Stereo Allowed’ or ‘Forced Mono’.
FM scan
You can choose whether your Elan E3 automatically stops at the next available FM station or the next
available FM station with a strong signal when scanning for an FM station. To change the FM scan
setting:
1. Press the Menu button.
2. Turn and press the Select dial to choose ‘Scan Setting’.
3. Select between ‘Strong Stations Only’ or ‘All Stations’.

DAB settings
Note: You can only see the DAB settings when you have selected ‘DAB’ as the radio source.
Full scan
You can use the ‘Full Scan’ (autotune) function to automatically scan for new digital radio stations and
remove inactive ones.
To carry out an autotune:
1. Press the Menu button.
2. Turn and press the Select dial to choose ‘Full Scan’.The number of stations found will be
displayed during the autotune.
When the autotune has finished, your Elan E3 will tune to the last station that you were listening to. If the
last station you were listening to is no longer available, your Elan E3 will tune into the first station in the
alphabetical list.
Manual tuning
To manually check the signal strength of a known channel:
1. Press the Menu button.
2. Turn and press the Select dial to choose ‘Manual tune’.
3. Turn and press the Select dial to choose the channels.

If no volume at all it is the unit amplifier. If volume but no adjusting, then the volume control needs cleaning/replacement.

U sure the radio is getting power?

This depends on the Music System. Check the manual, check in settings and see if there is volume normalizer or try keeping the eualizer in defult, or reset the system.

Most likely the audio amplifier chip needs replacing.Other wise you could try spraying "CRC 2-26" into the volume control assembly.

There are two ways to turn up the volume.

First the mp3 player has the volume dial turn that up all the way

Second there is a volume knob on the dewalt radio it is the black knob on top of radio on the right.

If those two knobs are unsuccessful make sure radio is on AUX there is a button on front right above the two arrows on front of the radio push that button until it says AUX that might be the reason your not getting sound

if the volume control is a rotary dial. The dial itself has gone bad or is worn out.  I'd most likely replace the unit as repair will be about the same price or more.  Buy an mp3 player instead.

not yet

make system microprossesor reset according to your model.
---try to make system reset by disconnection and connection.
if all above failed bring a spray lubricant contact cleaner from radio shack and apply spray in volume and channel buttons,

Ok my head unit is stuck on 10 with my valume and it wont change how can I fix that

Hi sounds like you have the audio out from the cd changer connected to the RCA/Phono out of the radio. double check that the output from the CD changer is going into the correct phono/rca connector regards Mark www.carradiospares.co.uk