Screen reads Loading and does not proceed further

When Kenmore HE Washer is stuck on Sensing Cycle and not proceed to the Wash cycle, most likely one of these 3 parts malfunction: Failed Water Inlet Valve or Inlet Valve Tap is in OFF position. Shift Actuator not able to change position, before Wash cycle. Control Board malfunctioned.

3 Top Reasons Why Kenmore HE Washer Is Stuck On Sensing

Videos as well, it is a known issue

https://www.google.com/search?q=Kenmore+top+loading+clothes+washer+stays+on+sensing

..

loading windows application or problem loading widget.
both mite be a fatal issue

www.ask.com/mfg.name/make/model/on/screen/reads/problem/loading/wid/

Hi ,
Hit several times F8 when starting up Windows and try to proceed further on in safe mode to see what happens then .
You can also try loading your W7 disc or a System Repair disc .
Have you checked all connections ? Do you still have power ? If not , the PSU ( power supply unit ) could be the problem .
Regards .

It sounds your Harddirve not working any more. The above mention error indicate the read failure of the hard drive.

me too get this prob but still not able to resolve it

when starting up the laptop keep pushing the F8 key

If the computer is restarting continously at the windows loading screen then you have a windows issue of which your computer is "Blue Screening" and restarting. In this case you arent really seeing the blue screen as windows restarts immediately as the error occurs. My advice to you is to press F8 before the windows loading screen and choose to "not restart automatically on error" that is not entirely what it says but its to that regard. If that doesnt work try pressing the "Pause Break button continously until the blue screen appears, read the error and google it to find out what is causing the error and go from there. Please feel free to get back to me on this if my information doesnt help or i need to explain further.

Press the reset button - you'll find it on the lower right of the Nüvi 255, but it doesn't look like a button. It's basically the sticker with all the information on it. It's just enough to push the sticker carefully with something small, not too sharp so it doesn' get destroyed. The Nüvi reboots, the loader loads and proceeds with the software load. Once this is over, shut down the Nüvi and reconnect to the PC. Then, everything works fine (it did at least for me).

- Press F8 during the boot,
- go to Safe Mode,
- After Desktop is displayed,
- restart the system in Standard Mode
If the problem is still there, you need to reload the Windows with Recovery CDs.

I have the same problem with my e250. is there any solution for this??