How do I remove cd changer for repairs? - Depo Auto Parts Subaru Legacy/Outback New Radiator Cooling Fan Motor 4 cylinder 2000 2001 2002 2003 2004 OEM 45121AE00A

If the disk is stuck in the changer then the changer has a defective part and will need to be removed and sent out for repair, Send a note with it that you want your CD back with the repaired changer.

Best Manuals this website has info on how to repair every part in car, try this website

Try pulling the fuse for the cd changer with the ignition on, and then plug it back in. If you are lucky you might reset the unit, otherwise the changer will likely need removed sent in for repair or replacement.

sounds like the tray inside was misaligned when the cd went in. and it probally sent the disc into a occupied slot. you will have to remove radio and disassemble to repair. also try just unpluging radio and plug back in. sometimes it resets the radio and will start ejecting the cds

CD ERROR DISPLAYS
CD Changers
E01:
The disc magazine is not inserted in the cd changer
E02:
No disc is inserted in the disc magazine
E04:
The disc is dirty, or the disc is inserted into the disc magazine
upside down
E99 RESET PROCEDURE:
Remove CD magazine by pressing eject button on changer.
Remove all discs from magazine and re-load empty magazine into
changer. Using the Radio RESET CD system by pressing and
holding the “ON”/”POWER” button for about ten seconds, or in
earlier models the “EJECT/6” button.


FM/RF Remote Controls
E99 RESET PROCEDURE FOR REMOTES:
Remove disc magazine from changer by pressing eject button.
Remove all discs from magazine and re-load empty magazine into
changer. Press RESET button on interface unit
WAIT:
The temperature is exceeding more than 55c(130f) and the cd
changer cannot be operated. When the cd changer cools off, this
wait disappears. When the RESET button on the interface unit is
pressed, this WAIT appears for a few seconds


IF THESE ERROR CODES STILL KEEP APPEARING
CONTACT YOUR DEALER.

cd changer off set common fault had it happen three times due to buttons being pressed to quick take changer out remove leads for a minute replace them turn on ignition should reset if not cd drive wiil need to be relined see dealer repaired one but really tricki

This is a common CD changer we see in shop for repair, see www.carstereohelp.com However, before thinking of repair, disconnect one of the main car battery terminals for several minutes then reconnect. This is easier then removing the stereo and reinstalling and acts as a reset for the changer. Otherwise, repair.

you can try disconnecting the battery for 10 min. to reset the system. If that dosent work then you will need to send the radio into a repair shop to have them manually remove the cd and repair the changer. (the changers are very fragle and break inside) you can send it directly to alpine to be repaired.their number is 1-800-421-2284 ex 860304

Remove the player and have it repaired, that is all you can do.

Hi try resetting the unit, or down powering the changer. this could reset the unit. if not then it wil need to be repaired