Tally t6218 prints and stops with no errors - Tally T6218 Matrix Printer

you need to check logic board.

problem for lipi 6312 tally genicom line printer my printer shows an error (hammer voltage 1)

In the T6215 Maintenance Manual the fault message: Hammer Voltage has been replaced, in the T6218, with:

Hammer Voltage 1
There is a new fault message for the T6218. It is:

Hammer Voltage 2
Explanation: A high resistance coil fault has likely occurred in one or more of the hammer coils
Note: This fault message will have been preceded by printing slow-down attempts associated with On-The-Fly thermal monitoring of hammer bank temperature.

Corrective Action:
Check the hammer bank for defective hammer coils.
Confirm that hammer drive board is functioning properly.

Click start>run>type services.msc. The services window will come up and you can right-click on the Print Spooler and then click Restart. This will clear the print queue and hopefully allow you to print. Good Luck. Let me know if you have any questions.

Check paper out switch behind tractor assembly. It may be bent and also make sure that the green bar (if used) is installed carrectly between the tractors.

may shuttle belt is lose or it is not in proper place. check the shuttle belt and clean the shuttel sensor , your problem will be solve.

there are two reason behind the problem . 1 .the problem may come from the logic board.
2.and the platen sensor. change the platen sensor. if not solved change the board.

dont use LF use FF to forward a form. if you use LF then set the topper form again.

Hi my tally printer 6218 giving Ribbon motion fault, what could be done to remedy this error message ?

it prints for about two minutes then starts slowing down and then stops printing showing an error of : hammer voltage 2