Question about GE Profile PSW26P Stainless Steel Side by Side Refrigerator

Open Question

Can I remove the white crisper drawer fronts to clean.

Spills have entered the front of the drawers between the clear plastic and the white fronts that I cannot get at and has started to mold. Looks like the fronts could come off because they are separate but don't want to force and break the plastic

Posted by Jerry Hendriks on

Ad

5 Related Answers

Anonymous

  • 1 Answer

SOURCE: Vegetable and fruit crisper drawers freezing foods

I had the same problem. Apparently the problem is the main control board. According to the technician that came out to fix mine there is a design flaw and these boards are very sensitive and can blow a circuit or malfunction from the slightest power surge. What happens then is that the control board doesn't "tell" the fan to turn on and off at the right time so the fridge and freezer warm up too much before the fan kicks in and then it cools everything down but since the fan isn't running at the correct intervals and circulating the air all of the cold air settles to the bottom which causes the produce in the drawers to freeze while the top shelves get warmer. I had done a fair bit of research before calling GE and came to the conclusion that this was a common problem. So I pressed them and was able to get the fee for the part waived (before I made the service call appointment) which was around $150. The part now has a 5 year waranty which I find funny, because I'm not sure why it wouldn't have that upfront as my refridgerator is only 2 years old. Whatever!! Unfortunately, unless you have indepth knowledge of refridgerator repair there is no way around the service call and labor. Anyone buying a new model of refridgerator (any company) should consider an extended waranty. The service tech also told me that all refridgerators made after 2001 are required, by law, to have an electronic mother board which in all likelyhood will fail at somepoint prior to when you are ready to buy a new fridge!

Good Lucak!

Posted on Feb 11, 2009

Ad
jumptrout51

steve

  • 3361 Answers

SOURCE: Vegetable and fruit crisper drawers freezing foods

You have a defective thermistor and damper control in the fresh food or a bad control board.
Check the thermistor first.
Also, adjust the return air damper at the bottom left side of the fresh food sction to warmer.

Posted on Feb 21, 2009

Ad

Anonymous

  • 585 Answers

SOURCE: removing refridgerator grill

Look at the top slots in the grille. If there is a slight cutaway near the ends that is where the release tabs should be. If no release tabs, try a gentle lifting pressure in the grille as you try to pull away. They are made to be removed by the user. Check the manual if you can find it. If no luck, reply, I'll see if I can find one.

Posted on May 28, 2009

David Shaub

  • 2976 Answers

SOURCE: Refrigerator crisper drawers are freezing veggies

Shut the air flow into the crispers if you can. If not, turn the refrigerator temperature warmer by just a few degrees. The air into the fridge from the freezer is channeled into the crispers.

Posted on Jul 01, 2009

Anonymous

  • 62 Answers

SOURCE: vegetables freezing in crisper drawer

This is an issue with the convection system in the refrigerator, while the cold air trapped withing the crisper drawer remains and the temperature of the moisture in the area drops below the freezing point, the water content acts as a cover and thereafter enables the vegetables to freeze. A slight rearrangement of the utensils within the refrigerator solved the problem

Posted on Jan 21, 2011

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I'm trying to clean the top of the pantry drawer in my 795-72053 refrigerator. Liquid has seeped between the clear plastic and the white. How can I remove this piece to clean it?


You have two drawers side by side that are called the crisper bins and one long drawer at the bottom typically called the deli drawer. I think what you are asking is how to separate the front (clear part) of the drawer from the back (white part) ,right?

Usually there are snap tabs that need to be pushed in to release the two pieces but I need to say that they are very fragile and break quite easily so be careful!

I would try soaking the drawer to get whatever it is cleared from it and let it dry completely. Keep in mind that there is usually a left and right specific drawer so if it doesn't fit then do not force it!
s-l225-5dtrzrhacenyq0nfrt1kdhhl-3-0.jpg

ajp73314402-5dtrzrhacenyq0nfrt1kdhhl-3-2.jpg

Jan 28, 2018 | Refrigerators

1 Answer

My E profile has mold in drawers. I can't reach. How do I disassemble drawer to clean


The drawers will pull out the front, then you can unclip the drawer fronts, they are just held together by plastic tabs. GE Refrigerator Drawer WR32X10338

Jul 10, 2016 | GE Profile 25.6 Cu. Ft. Side-by-Side...

1 Answer

How do you remove the clear plastic cover on the crisper drawer of a Samsung Refrigerator Model RF4287HARS


Yes, the clear plastic front of the crisper drawer can be removed for cleaning. Using a thin-bladed, flat-head screwdriver, pry out at the clear plastic slot at the top outside of the drawer, where the clear front piece meets the tab of the white handle piece. Pry out just enough to get the blade under the slot, and then pry inward at the white tab to release the clear front piece at the top of the drawer. Repeat this procedure on the opposite side, so that the plastic front piece is free at the top of the drawer. Next, turn the drawer over on a counter and work the blade of th screwdriver under the tabs at the bottom of the front plastic piece. These should release easily. Notice the bottom edge has three slots and two sections that are interleaved with the bottom of the drawer. Once you have all three pieces separated, the while u-shaped handle piece, the plastic front panel, and the drawer itself, you can clean and dry them easily. To reassemble, first snap the while handle into place on the drawer, by lining up the top of the drawer to the while handle part first. The top of the handle fits over two plastic extensions on th top of the drawer, then swings down to cover the front sides of the drawer. Then reattach the bottom of the front plastic panel to the bottom of the drawer, interleaving the overlapping parts and snapping the tabs in place. Then snap the top of the front panel over the white handle at the top of the drawer, and you are done!

Dec 04, 2014 | Samsung Refrigerators

1 Answer

Door shelf, need to take it apart.


Gently squeeze the sides of the clear door to allow its pivot pins to disengage from the surrounding plastic. After cleaning, repeat the process to reinstall it.

Dec 02, 2017 | LG LBC22518 Bottom Freezer Refrigerator

1 Answer

Mold above the detergent drawer, how do I disassemble it?


That one screw only hold the front console in place(it actually has numerical plastic locking tabs that hold it with or without the screw)
I think to get to what you want just removing the very top(lid) of machine would be sufficient. There are 3-4 screws at the back top and then you lift up and pull back to get lid/top off. I would not recommend trying to remove the console in the front. I hope this helps... If I can help with anything else please let me know.

Mar 19, 2010 | Whirlpool Duet GHW9150P Front Load Washer

1 Answer

How to completely clean the Crisper drawer


I don't know if you've already figured out how to remove the front panel on your refrigerator crisper bin, but here it is. Once the drawer is removed, pull back those clips on the top left & right of the front of the drawer.Just hold the side and pull back at the same time, then you can remove it. Once both side have been released you should be able to remove the clear plastic front and clean both pieces. I hope that is clear enough. Best of luck, unless of course you've already discovered the answer yourself.

Feb 21, 2010 | KitchenAid Refrigerators

1 Answer

On an LG 2277 washer. I try to start a load. I get error message: "de"- door not closed. It looks to me that there must a switch to sense if the door is closed. Where is this switch located and how do you...


The switch is behind the front panel - to remove it, unplug the machine and:

1. Open the panel where the drain filter is (lower left side of the front panel)
2. Remove screw visible inside this area and remove the white molded plastic - also remove the screw behind that plastic.
3. Open the washer door and remove the spring loaded wire around the door gasket. Carefully pull the door gasket away from the panel push inside and then reclose the door.
4. Remove the detergent drawer and the two screws visible behind it.
5. Pull the top of the electronics panel away from the machine and lift up - place on top of machine or hook it out of the way
6 Remove the 4 screws that are visible holding the front panel to the machine. Left the entire front panel up about 2 inches and swing to the right

The wire connecting the panel to the machine on the right leads to the switch and door lock mechanism

Apr 25, 2009 | LG WM-2277HW Front Load Washer

2 Answers

Cant open soap drawer on washer


I opened up the top of the washer by unscrewing the screw in the back. then I pressed down hard on the white plastic cover of the soap dispenser that you will see on the front left hand side of the machine. I also moved it slightly to the right by pushing on the side of the same unit.

The soap dispenser then opened up fine. I cleaned out the soap dispenser from any crud that developed in it. Now it opens and closes nicely.

Did you know there is a class action lawsuit against LG for mold that develops inside of this model washer? I joined in the lawsuit. There should be no mold accumulating in any washer.

Sep 07, 2008 | LG WM-1485FHD Front Load Washer

1 Answer

Maytag Neptune Washer dispenser unit has mold and mildew inside top of dispenser compartment.


You can pour the bleach in the drawer every time you do white loads and it will stay clear too!
Just flush it out good before you do colored clothes or you may get a small bleach spot on a red shirt !
Neil
Ps. Give me a problem solved rating here on fixya.com

Aug 19, 2008 | Maytag MAH6700AWW Neptune Front-Load...

Not finding what you are looking for?
GE Profile PSW26P Stainless Steel Side by Side Refrigerator Logo

Related Topics:

758 people viewed this question

Ask a Question

Usually answered in minutes!

Top Refrigerators Experts

Ron Rak
Ron Rak

Level 2 Expert

138 Answers

gbob59

Level 3 Expert

3063 Answers

Cindy Wells

Level 3 Expert

6187 Answers

Are you a Refrigerator Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...