I am looking for wa10r3 samsung washing mahine washing but wont spin,sounds as if is spinning but wont spin.please help me

motor is broken try cleaning bushes easiy fix

the motor spins with out the belt , makes me tend to discount the capacitor
I would be looking for a tub brake that is not being opened to allow the tub to agitate
there are solenoid activated brake under the machine the applies a brake when you lift the lid during wash, when the program is finished
have a technician check it out

Sounds like the belt either broke or jumped off the pulley. should be a simple fix from the back access.

no idea without a look but i suspect the contacts on the motor armature

Hi,

Problems with a washing machine not spinning or not draining are often interrelated..

If you are having a problem with your top load washer then check out thistip...

Washing Machine does not Pump or Spin


If you are having problems with your front load washing machine then checkoutthis tip...

Front Load Washing machine not draining and or not spinning


heatman101

';';

Could be heater. Try machine on rince cycle.Not pressure switch. If mahine works on rince then chances are heater. But this should not affect spin

can you tell if the motor is turning,if so it could be your idler pulley and youve lost belt tension,otherwise it could be your motor start capacitor if motor spins freely with power and belt off

There is a capacitor linked to your motor by wiring.. That capacitor is most likely the fault... It is normally a 400vac 12UF(J) capacitor

not a fun belt to change on this mahine, thinkin youll need to unmount the motor under the unit to get it on. is it physically broken???

THERE IS NO BELT ... IT IS USUALLY THE LOADING DOOR SAFETY SWITCH THAT SHUTS OFF WASHER WHEN DOOR IS OPENED DURING SPIN CYCLE. THAT SWITCH CAN GO BAD. THIS IS NOT AN EXPENSIVE REPAIR ...