Mine has broken where can I get a replacement

Universal remotes have severe limitations and aren't suitable to replace a lost or broken original remote.

If a genuine replacement cannot be found, try searching for a compatible remote. These provide most of the functions of the original including menu access. I think I bought mine from Amazon or ebay and it cost little more than a good universal.

I'll buy your third latch to fix my Golf Guard. Or sell you my remaining two and I'll scrap the rest of the case. Looking for a soft side anyway.

OEM Replacement Parts DIY Repair eReplacementParts com


Should have the parts but you will need to put in the model number. That will give you a schematic from where you can get the part and also order it from them. At times they will also have a video on how to make the repair.

Hello
If your Technica TV asks for a four digit universal code; buy onw RCA RCR311B model remote control. The codes for Technica with this remote control are:
1004, 1006, 1009, 1010, 1013, 1025, 1035, 1045, 1051, 1060, 1061, 1075, 1078, 1103, 1122, 1123, 1205
If it asks for a five digit code, buy RCA RCR 312W model remote control
Codes for Technica with this remote control are:
10054, 10180, 10150, 10060, 10092, 10016, 10056
Otherwise, give me the Brand Name and Model Number of the remote control you have with you now, and let me search whether there is any code for Technica TV, with this remote control. OK.

You cant just replace the gear yuo will half to buy the Gear Case Assembly Part Number: 623586-00SV $31.01 ereplacement .com

Call the service # and they will send you a new drill, mine had a burn mark right through the switch and with the model # they replaced it mine was a21.6 they are having troubles with the triggers i pulled mine a part and when i put a battery in it it would run continuous , the number should be on the drill1-800 590-3723

to my knowledge you can't buy hilti parts. they want you to send it to a service center. i work in a tool repair shop and we can't get parts. i would go to a shop that repairs tools and have a number of brushes and try to find one that will match up.

Two ways to do it. You can get a new one at the Dealer ($$$'s), or a universal replacement at Pep Boys and maybe Autozone (at least in my area) or you can try what I did. Take the remote apart like you would be replacing the battery. Find an area that is clear from the circuit board underneath. On mine it was right near were the ring used to attach. Drill a small hole through this clear area (have to drill both halfs, Insert a new ring and your done.

Mine has a set screw some of them might threaded

Just some added information. The number you have may be a part number. I ahve the exact same number on my Bosch Universal Mixer. What i'm looking for is a new casing, mine is broken.