How do I remove the warming drawer - Kitchen Ranges

Can you pull the stove away from the wall if it is a gas stove?

I had the same problem - here was my fix...

If you remove the warming drawer you will see the heating coil underneath the drawer held in place by three c-shaped clips that are screwed to the bottom of the stove. I finally realized the two front clips (open to the front of the drawer opening) had their tops pushed vertical and that was what was blocking the drawer from going back in. I bent and hammered the clips back into shape and also hammered the bottom of the drawer back into shape where I had bent it on the clips. Then was all good following the manual instructions.

From the scratches on the drawer bottom, it looks like the clips were installed that way at the factory. This was the first time I's had the warming drawer all the way open.

Usually there will be tabs or small levers on the slides that will have to pressed in or up or down that will allow you to remove the wrming drawer.

yes.

There is a 'plug and socket' connector at the back of the warming drawer which does wear and eventually start to make erratic or no electrical contact. The drawer electronics read this as an open drawer and switch off the power to the heating element (flashing red light). If your competent the drawer can be stripped down and the contacts serviced or replaced otherwise consult a service technician.

open drawer- use hot dog tongs and fish for rack- or a large kitchen magnet on a string

Found that there is an electrical connection at the point the main electric enters the back of the stove. There is a connector for the element that was not connected. Now it works!

To remove the warming drawer you should pull drawer all the way out until it stop and than lift it up and pull forward.

I’m happy to help further over the phone at https://www.6ya.com/expert/vitaliy_f406165329c75ede

There is no warming drawer, only the YKERS807 has the warming drawer