Why is reading EE,? new batteries and all connections secure.

Device Errors
Error or symbol Cause Resolution
Device shows “EE”   Cuff is under?inflated, or has
not been applied correctly.
Device shows  
"E
  E" vertically in two lines
Cuff is over?inflated.  
Single Mode:
The monitor will attempt 1 reading.
TrueRead™ Mode:
The monitor will attempt up to 5 times  
After  the automatic attempts, remove
the arm cuff.  Read, “Taking a
Measurement” in the instruction manual.  
Take another measurement.
Monitor could not detect
pulse wave.
Device shows ‘E’
Air plug is not connected
Check air plug connection.  Take another
measurement and remain still until the
measurement is complete.
Device shows “Battery
picture with a cross mark”
Batteries are worn Replace the four batteries.
Refer to “Battery Installation” in the
instructionj manual.
No Power
No Display appears on the
unit
Power off
Check that the device is turned on.  
Check the battery installation for proper
placement of the battery polarities.
Replace all four batteries with new ones.
If running from a wall outlet, check that
the cord is attached to both the device
and outlet

Most likely device is defective

The more recent models don't have to be tapped before getting on,if its an older one, the message might mean you took too long or weigh more than the capacity,usually 300,or 330lbs for a digital scale although some go to 400lbs or more. Try switching the battery for a new alkaline or lithium one;digital scales often need more power than a common cell can provide.

WINDOW 8 IS NOT GOOD FOR DRIVERS WE HAVE TO INSTALL THEM AS ON WE DO IN xp

I doubt if your watch is faulty. If you read your instructions I would expect you to be able to empty the memory.

You can get instructions from the Timex web site "timex.com".

At the bottom of the screen click on "manuals/downloads", then on "product
manual download"

Enter your watch type in the search box and click on "search"

Check out your monitor's manual to see what "EE" error message is stand for ?

Having received no response in over a month, I assume this is no longer a problem.

I just took my DP-R99 out of the closet and powered it up in my garage. After a short delay it reads EE. I took it apart and the belt that drives the laser head up to the CD and pressure disk to make it spin is slipping and never raising the head enough. It looks like the belt has stretched over the years. I am now going to look for a replacement belt and the belt that rotates the carriage since it is also stretched. I will let you know for sure when I install new belts. Hope this helps...

From what i have seen EE means overload warning, I looked on the website your scale has a lifetime warrenty on it i would recomend calling customer service @ For Customer Service: 800-289-0944 before messing around with anything.