How to take the panel off to replace dispenser system DA97-12095a

Get rid of it and instead install a filter system ( double or reverse osmosis) under the counter.

Turn the temp down on the refrigerator side but not below freezing. Some frigs have a "trap" set up for the water dispenser. its located behind a panel in the frig and it is there to help chill the water before it dispenses. if the frig setting is too cold then it can freeze the water .

If you need further help, reach me via phone at https://www.6ya.com/expert/steven_a67ead41eb5fc62a

Try replacing the filter again, If it works again then you might want to think about putting some sort of water softener system in your home

If you need further help, reach me via phone at https://www.6ya.com/expert/steven_a67ead41eb5fc62a

This is a complicated system to diagnose, and one not recommended by the average DIYer. I would recommend in this case to have a qualified whirlpool technician at least inspect and give you a diagnosis. Due to its complicated nature, and the difficulty in accessing all the parts needed to test, if done incorrectly, you could further damage the door, or the dispenser module.

repairs should be performed by a qualified technician. if there isn't ice in the ice bucket located in the freezer you have a water flow problem. if there is water going to the filter and nothing out of the freezer then you have a clogged freezer replace it. if these things are ok then yes it could be the electronic control. filter failure is a common problem.

if its a whirlpoo at the bottom of the trim there are two slots use a flat head pull down and pry out

you may have dislodged a sensor or perhaps you may have blocked your water line somehow... im not sure about this specific model, but just try having a look at what you did and see if there are sensors around there.. and make sure u havent dropped anything in there wich may have clogged the lines... lets hope its not your solenoid that has gone, sounds unlikely though you never know