TV:G how do i turn off the TV:G mode so it stops bleeping out stuff?

vehicle in limp mode need to have scanned for problem

Barrie, what do you mean bye bleep? And what kind of tv and what kind of service( directv/cable)?

is there a red light or nothing ?



TV Repair Service Television Repair Tv Repair Toronto Mississauga...

hello, i had the same trouble all i did was reset the console press and hold the standby button on the front of the ps3 you will 1 bleep then 2 short bleeps after the short bleeps release the button it should reset hope it helps

regards
shaun

hello, unplug all the cables from you ps3, turn the power off on the ps3 then turn it on press and hold the standby button on the front of the ps3 you will hear 1 bleep then 2 short bleeps after the short bleep relase the button, also turn your tv off then on again, when your ps3 comes back on plug the hdmi cable into your ps3 and then into your tv hdmi 1 on the tv go into the menu find hdmi click on this you should get a picture and sound hope it works

regards
shaun

hello have you tried to reset it.while in standby mode press and hold the power button you hear 1 bleep then 2 short bleeps release the power button this should reset the ps3 make sure you've got it connected to the tv screen hope this helps

regards
shaun

Have you tried to unplug it, and leave it out for a few minutes, then repower, this clears the volitile memory.

Ed

When the machine is on, but not running, press and hold the "pre-wash" button. After a few seconds it will begin that beep noise, keep holding it in until the beep volume goes down and finally stops. Once the beep has stopped, release the button and voila, no more annoying beeps at the end of your cycle.

To restore the end of cycle notification (beep) do the same thing as described above, but release the button earlier while the beep is still going.