Microwave stopped heating up. Took old door switch/microwave switch/door switch assembly out. Noticed one door switch with burnt connector at wiring connection. Also, plastic frame slightly damaged. So, replaced with a new assembly. I bought on ebay for $16. Put it in and still microwave doesn't heat anything..but now convection oven is heating up the inside of oven when I press microwave button. When I put back 11 wired connectors to computer panel, they all fit as they are color coded and size coded....What could be problem?
My guess is that something has not been reconnected correctly, or there's a bad connection. I'd re-check all connections. If possible, use some electronic contact cleaner on the cables that connect to the control panel.
If you need further help, I’m available over the phone at https://www.6ya.com/expert/david_29ad5d1dd86564b0
Check three thermal fuses.
SOURCE: Microwave door has burnt patch: is it safe to operate?
From your other post:
The
paint should be available at big box stores like Wal-Mart, home
improvement centers like Builder's Square, Lowe's, or Home Depot, or
hardware stores or local appliance parts stores.
You can order the plastic sheet (called the "door film") here. It is part # WB06X10490.
Be sure the mesh is clean and dry before installing the new film.
We're happy to help you and we'd appreciate your
thoughtful rating of our answer.
SOURCE: Daewoo WM1010CC convection/ microwave combo unit issues
Likely takes a torx wrench or some other special star tool to open it.
Could be a bad relay a bad mag tube or a bad timmer or a bad door switch. Needs to be trouble shooted. You have to get it open and check the fuses and test the voltage on the pri transformer first.
SOURCE: GE JE1860 Microwave is not heating
Test the high voltage capacitor,the rectifier diode.or the magnetron. If all this are fine, test the control board.
The
diode and capacitors can br tested. The capacitor must be
alloweddischarge before testing, or you risk to get electrocuted, even
ifpower is off. Capacitors can get discharged by shorting their
twocontacts.
Before replacing the magnetron test also the control board.
Replace the magnetron if the checks and all of the high voltage component tests are good, but the unit still does not heat.
All locations, and description of this parts can be located using the diagram here: Counter top.
Parts must be tested to find out what is wrong.
Remember that microwaves are potentially dangerous devices if not repaired properly, the job must be done by a competent person.
A microwave energy leakage test must always be performed when the oven is serviced for any reason.
Regarding parts, contact the seller here to purchase parts. (here in UK).
SOURCE: Microwave part of my GE Sensor Convection Microwave doesn't work
Hi,
Here is a tip that will help you to figure out what is wrong with your Microwave Oven....
Microwave Oven Basic Troubleshooting Tips
http://www.fixya.com/support/r5508031-microwave_oven_basic_troubleshooting
heatman101
SOURCE: convection oven won't heat?
Hi,
Here is a tip that will help you to figure out what is wrong with yourMicrowave Oven....
Microwave Oven Basic Troubleshooting Tips
heatman101
dgj
211 views
Usually answered in minutes!
×