Will not spine in spine cycle - Maytag Bravos MTW6600T Top Load Washer

The transmission could be at fault

pump prob check for blockage

could be defective part or lid switch problem

From the limited information you provided, I would concentrate on the transmission. Most are a two speed transmission - low for wash cycle and high for spin. If it isn't doing either, you should make sure that it is getting a signal to the transmission from the control board.

Your load is probably unbalanced. Open and redistribute the garments or take some items out.

washing mechine not spining wahing ok why?

its a simple solution just remove the brown colour clamp at the bottom of the machine with a screw driver

It is probable your lid switch.

There is a transmission clutch that engages for the spin cycle. A gear has worn or broken a tooth. Replacement of the transmission hispeed spin cycle assembly is required.

The other comments are of no use. You must get parts from an Authorized Fisher & Paykel dealer, or have an authorized repairman service the machine.

hold cancel for 10 secs
hold end of cycle signal 10 secs.
one of them should reset it.