Have a Samson sx2800. Powers on but no out put sound. What could be the problem.

When any electrical item doesn't work after being moved, suspect some kind of physical cause. Such as a bad soldering joint or other damage inside caused by an unknown bang or jolt during the move. Perhaps even an alien object inside like a metal pin etc.

YOU HAVE A ELECTRICAL PROBLEM.
CHECK ALL ELECTRICAL WIRES,CAN BE A LOOSE WIRE.
ALSO CHECK ON/OF-BUTTON.
IS THE POWER-SUPPLY OKEY ? IF NOT SURE,CHANGE PSU.

So, if I am understanding you right. As you are talking on the mic you are cutting out as if it is shutting down. If this is the case I would adjust your settings. It sounds like it is clipping from maxing out the input. A protection is cutting you out. Let me know if this is not the case.

I know this is an old post. I put this here for others with the same issue as I have worked on these before. Call Samson and ask for the schematics - they will email them to you if you ask nicely.

As for issues I have seen with these:

The protect relay on many of these is notoriously cheap (Alesis used the same brand and also had difficulties). This is worth checking straight away if your power supply seems good. It is a DPDT12v on the control side and rated at 5 amps (the relay will say 10, but it's 5 amps on each pole).

I also had an issue with the PCB being bent within the enclosure as it fits very tightly in a plastic shroud, and then into the wooden enclosure. This caused some of the solder joints to come loose on two of the power transistors. So, if you see that the PCB is bent a bit, check all those solder joints.

Hope this helps someone.

You need to select Samson C03U as the Default Device. Do not select Realtek. Realtek is the sound card that's built into the computer.

the servo series is geared more towards studio applications and/or installs, while the sx series are geared for live pa applications. the servo 600 is 300 watts per channel @ 4 ohm, and the sx1200 is 450 watts per channel at 4 ohms. the sx amp can also be bridged over to mono mode, where it puts out, i think, 1100 watts mono.

the only variable i havent been able to cover is sound quality, and im not seeing those listings in the specs on the samson website

The gateway site has all the manulas etc that you want.

http://support.gateway.com/

I'm not really sure if your asking for the user's guide for the SX2800 or the systems manual for the OS. The first link included below will take you to the User's Guide. Although this is a generic guide it is the one that comes with the SX2800.
The second will take you to the support page for the OS's. You will need to click on your OS and choose which what info you need, like recovery or general support information.
Hope this helps.



http://support.gateway.com/s/Manuals/gateway/GatewayDesktopUsersGuide.pdf

http://support.gateway.com/support/supinfo/index.asp?pg=2&file=sw.html

Are you trying to connect to the wireless network on the SX2800-01 or it is connected with the ethernet cable to the router ?
Click Here for more info about Internet problems.

What computer are you using?