Question about NewAir Heating & Cooling

1 Answer

How do i get my newair af 1200e portable air conditioner to stop blowing cold and warm air.

When i turn the unit on it only blows cold air for about 5-7 mins. After that the air is blowing warm for about 10 mins until the compressor kicks back on. Help!!

Posted by Kawan on

Ad

1 Answer

william simpson

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • NewAir Master
  • 1,363 Answers

That is normal operation when thermostat setting is reached it will cycle off compressor.

Posted on Sep 10, 2015

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

It blows cold air for 5 min. and the it blows cool air for 15 min. the room warms up . Why does it stops blowing cold air continuasly???? The thermostat was disconectet on purpose so it coul clow cold air...


See if you can reposition the thermister on the facing of the evaporator coils. That could be it or the thermister might be bad. They don't use copper/mercury sensing bulbs these days. They use these cheap thermisters.

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

May 22, 2010 | LG Heat cool Window Air Conditioner

1 Answer

The electricity went off this morning and now the air conditioner is blowing warm air and I don't hear the compressor coming on its a whirlpool window unit Thank You


turn the unit off for 5-10 mins. turn thermostat to coldest setting then turn unit back on. see if the compressor kicks on in a minute . it may need to reset itself.

Jul 30, 2009 | Whirlpool Heating & Cooling

3 Answers

Uotside unit blowing cool air but hot on the inside


It sounds like you have a unit called a heat pump. When a heat pump unit is in cooling mode the outside unit blows hot air and the inside unit blows cold air. If the outside unit is blowing cold then the indoor unit is most likely blowing room temperature or warm air. It sounds like the thermostat could be controlling incorrectly or you could have a failed reversing valve which is the device that switches the unit from heating to cooling mode.

May 31, 2009 | Ruud UBHC Air Conditioner

1 Answer

Will not cool properly.


You have either a faulty thermostat, dirty condenser and evaporator or a faulty run capacitor. Need to service soon before the compressor is damaged. Sea Breeze

Jul 31, 2008 | Kenmore 75101 Wall/Window Air Conditioner

1 Answer

Poetable AC compressor licks in for 10 min


It is probably either the high pressure switch or the frost control. The high temp switch usually trips because the condenser coil is dirty which does not allow it to exhaust heat very well. The frost control will trip if the system gets below 39 degrees on the pipes. This is usually do to low refrigerant or dirty filters. Good Luck!

Jul 03, 2008 | Maytag Portable Air Conditioner M6P09S2A

2 Answers

No cold air


if unit is more than 5 yrs old dump it!!! most frigidaire models just dont last...that is why they are so cheap...get it???

Jun 09, 2008 | Frigidaire FAH085N1T Air Conditioner

1 Answer

Comp shuts off


Coils could be dirty. Compressor could be getting too hot and cutting off. Will have one fan motor that turns condenser fan and evaporator blower.

May 30, 2008 | Fedders D Chassis A6D24E7A Air Conditioner

Not finding what you are looking for?
Heating & Cooling Logo

Related Topics:

231 people viewed this question

Ask a Question

Usually answered in minutes!

Top NewAir Heating & Cooling Experts

gbob59

Level 3 Expert

3063 Answers

Tom Chichester

Level 3 Expert

59234 Answers

Bill Boyd

Level 3 Expert

53816 Answers

Are you a NewAir Heating and Cooling Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...