How do I set the digital clock - Ovens

To access the clock controls, press the "Stop clear" button, press "User pref," and then press "5." Use the number keys to enter the time as a four-digit number. For example, press the "1," "2," "3," and "0" buttons to set the clock to display 12:30. Press "Start enter +30 sec" to complete the process.

yes...mostly. they are the "second hands" of the clock...sometimes, they indicate "cooking" or "timer"...but mostly they just blink to show the clock

Hi Jason. Have you performed the following actions?
Electronic Timing Center (Analog Clock w/Digital Display)
Synchronizing the analog and digital clocks
1. Press the "timer" and "start time" buttons simultaneously.
2. Turn the set knob to move the hands on the analog clock to any time setting.
3. After five seconds the display will go blank. Press the timer button and using the set knob, set the digital time to the exact time on the analog clock. This will synchronize the two clocks. You can now set the time of day.
Setting the Time-of-Day
The time-of-day must be set before any other program can be used. When your oven is first connected to the power in your home, the digital display will show 00:00. To program the time-of-day:
1. Push and hold the "timer" and "bake hours" button at the same time.
2. Turn the "Set" knob until correct time is displayed on the digital clock.
3. Release "timer" and "bake hours" button
The analog clock will automatically set after the digital time is set

Let me know so that I may follow up if need be.

Press bake and set temp. to highest setting on some it's 500 on others it's 550 aftef setting to highest bake setting. Press and hold bake button until 00 is displayed,use up/down arrows to adjust in 5 degree incriments to plus/minus 35 dergees . ONce you've adjusted it push cancel/off button and you adjustment will be stored even if power loss and clock went out.
If your temp is more than 35 degrees off the clock needs to be replaced

No solution I'm afraid, just exactly the same problem, have you managed to fix yours?

bad digital control board if tis just a clock and all the settings can be done with a knob and not the board then the replacement wont be too expensive but if that board controls eveything which i suspect it does then its going to be at least 150 more to repair than if it was just a clock display

It depends on the make and model but generally there is a dial for the oven and you turn the dial to the required temperature and this normally brings the fan/heater/light on.

Setting the clock depends on wether it is digital or no.

Analogue clocks usually have a large button in the middle of the dial which you turn to set the time.

Digital clocks normally have buttons marked + or - which you depress to set the time.

Hi

have you tried setting the clock as the oven wont work if the clock is not set. hope this helps

regards dan

Hold in the button for a few seconds and the numbers will flash. Then use the up or down arrow. Should do it for u. good luck

Bad clock assembly although the clock works the solid state switches internally typically go bad even on brand new ovens,does broil work,the top elements should work?