I don't have a remote and need to know how to set the input manually

newer tvs need to know that HDMI is attached to give you signal also need to turn on device from where HDMI signal comes from.post the model of your tv ,or if universal remote has input try this,1.- connect hdmi ,2.- turn on device(dvd,ps3,blue ray, etc.) 3.- press input on remote ,or go to menu manually on tv and find input.hope it works.

Unless there is a source or input button on the set you need the original remote.

If you get a cable box that has audio/video outputs on the rear connect them to a identical input on the rear of the set----direct connection and bypasses the coax fitting most sets have.

Go to the input you hooked to and leave set there--change channels via the box with its remote or manual buttons.

You need to connect the activation input wire on the starter, two negative pulses.

MOST OF THE VERY OLD SETS THAT HAVE THE JACKS ON THE BACK CAN BE ACCESSED BY GOING TO CHANNELS 90,91,92.

If no jacks on back of set you are out of luck.

Let me know what you find before you rate this information.

SD TECH

Hello
Get into this link from where you can download the user manual for your remote control.
www.voxxsupport.com/.../User%20Manuals%20.../RCR312W_DOC_OM.p... OK.

If you use the yellow, red, white jacks, these are called RCA jacks.
The tv should have these. Some have two sets of these. Make sure yours are hooked up to input or a/v So run xbox cords to tv input or a/v jacks.
Then turn on your tv and turn it to input or a/v channel
Some tv remotes have an input button on them

If you have any other questions just ask.

Please try this:
With your remote set on AV1, push the input button and try to change the input using the up and down arrows. You want to set it on cable or whatever your TV input normally says. I have Satellite TV and mine says satellite. You should be able to easily change it with the input button. If you can't do it, change the setting on your remote to TV and then try the same procedure. The Sony Bravia has manual controls on top of the set as well. If you are unable to change your input using the remote, try the manual controls, however, your remote does need to be reset for the correct setting as well. Using the manual controls will just help you check to see if there is actually a problem with your TV. Is this a new TV, new problem?Have you changed batteries in your remote recently?

I hope this helps you. If not get back to me, and let me know.
Thank you for using FixYa.

What is your universal remote control? if its not philips magnavox you try this universal remote control you will set the code match to your tv sanyo which you will see at the back of the instructions manual when you buy this remote control. follow the instruction of the manual on how to enter the code for tv. thanks.God bless you. i hope it will help.

If you have a "Menu" button on the front panel of your set, then you may be able to change settings from the menu this way. If not then you will have to have the original remote to change settings. Stargazer