Question about Kodak i4200 - document scanner

Open Question

U9 error code right after the machine is turned on

Posted by Anonymous on

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Kodak U9 error code. How do you clear it?


we are facing problem Kodak i4600 scanner error u9 .we replaced udds Sensor same problem.

Aug 22, 2013 | Kodak Office Equipment & Supplies

2 Answers

SHARP-235, F5-02 CALL FOR SERVICE CODE


Sep 2010 ... What does error code L6-10 mean on a Sharp AR-235 ... my machine sharp a 235 say call for service u9-99 what dos it mean and how can i

Sep 04, 2010 | Sharp AR-235 Copier

1 Answer

Code u9-80


This indicates a communication failure between the Main Control Unit and the operation control circuit board. Power the machine down and disconnect from hte power supply. Check all the connectors and wiring on the boards and also any loose wiring that may be grounding the machine. Power back up and if the fault persists a qualified copier engineer will be required.

Mar 10, 2010 | Sharp AR-M237 Copier

2 Answers

Xerox u9-5 code on a 5028 copier


Hello sir; There is a reset procedure require;
hold down 0 while you turn on the power, then enter 20 press start enter 3 press start. turn power off and on.

Aug 19, 2009 | Xerox Office Equipment & Supplies

1 Answer

The air conditioner wasn't on and the control box was displaying a U9 error


u9 error code means there was a problem with voltage to the unit.Can be caused be either overage or a shortage. Have you had any power outages?

May 12, 2009 | Heating & Cooling

1 Answer

WORKCENTRE PRO 420 U9 CODE


Hello sir; The U-9 code means the main control unit/switch board problem, replace it.

Feb 07, 2009 | Xerox WorkCentre Pro 423 Copier

1 Answer

Rank xerox 5328 U9


if its a u9-1 code it is the lamp that is faulty. Sometimes it can be the connections either end of the lamp but normally the lamp itself. It will probably cost as much to fix as it would to get a new one to be honest

Nov 03, 2008 | Xerox 5830 Copier

1 Answer

Xerox 5328 copier error


U9-3
Xerographic process problem.

The Exposure sensor detected low Exposure Lamp intensity. Switch the Main Power Switch off then on in order to clear the Status Code. Go to the U9-3 Xerographic Process Problem RAP

U9-4
Xerographic process problem.

The Main PWB sensed that the Toner Dispense Motor was not running. Perform 20-3 U Codes Clearance . Go to the U9-4 Xerographic Process Problem RAP

U9-5
Xerographic process problem.

The CSDC zero point was too high during auto setup. Perform 20-3 U Codes Clearance . Go to the U9-4 Xerographic Process Problem RAP U9-5 Xerographic Process Problem RAP .

Aug 09, 2008 | Office Equipment & Supplies

2 Answers

Error code U9


That code normally means you need to do some cleaning to the machine. The majority of the time it is caused by High Voltage arching.
1. Open the right hand door. About mid way down you will see an opening with a very fine wire in it. just a little thicker than a hair. Take a Q-tip with some alcohol and clean that wire. Also gently brush that area BEFORE cleaning with a q-tip to remove as much ink frmo the channel as you can.
2. Towards the top of that door, there is a metal strip, looks like a saw blade, has triangular points on it. I would assume it is pretty black now and not silver. Take a brush and clean that. then gently take a cloth dampened with alcohol and wipe it , very gently until you get it reasonibly clean.
3 Remove the drum cartridge and look for all the contact points. Mostly the ones on the lower right side. Clean all the ink ( toner) from that contact area and look around for all the other contacts to that cartridge.
I would say there is a 90 percent likelyhood this is your problem.

Low line voltage and line spikes can cause this problem, But far less likely.

Feb 06, 2008 | Xerox 212 Laser Printer

2 Answers

Error code U9


hi im jules_09,are you sure its an error code?chek first all sensor on front door and other parts of the copier that has a sensor,

Nov 02, 2007 | Office Equipment & Supplies

Not finding what you are looking for?

Open Questions:

Kodak i4200 - document scanner Logo

Related Topics:

240 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kodak Office Equipment & Supplies Experts

Cindy Wells

Level 3 Expert

6198 Answers

Muntejaya Ginting
Muntejaya Ginting

Level 3 Expert

10422 Answers

efs_perpends
efs_perpends

Level 3 Expert

1997 Answers

Are you a Kodak Office Equipment and Supply Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...