What is the db on spin & wash - Zanussi FJS1225W Front Load Washer

u should beable to turn power off to washer for 5min an door should unlock if not you may need to call a appliance repair service ok

Not sure if you have already figured this out or not, but it may be necessary to shut off the machine or unplug it to get the access you need. I have a Kenmore front load and there are some cycles other then spin, that will not allow you to stop and open the door - water in the drum and washing is one of them.
I have not had to try to open my unit but the above is what I would be trying if you have to get the door open. If the washer is still going, then maybe try to ignore the alarm beep and let it go until it gets to a stage where you can interrupt the cycle

it's from an unbalanced load,you can try unplugging it or kill power to the washer forlike 10 minutes to reset the computer board and hopefully this will do the trick,i've never seen this code,i goggled it and found it's from an unbalanced load.hope this helps

did you ever read a manual

device in the eu or east need to have the rating as a label

so look up the manual you either have one and cant be bothered
or just cant be bothered to look it up

how many DB between 90 and 120DB max in europe as a device that outputs noise
and more you need a special license for

Decibel is what sound is rated in.

The sound level is expressed as a line.

0 in the middle.
Negative values are to the left, Positive values to the right.

Less DB rating to the Left, more DB to the Right.

Anything above the 0 is louder. 1, 2, 3, 4, 5, 6, etc.
Anything below the 0 is not as loud, -1, -2, -3, -4, -5, -6, etc.

It would be correct to state a 6 DB loss as -6DB.

Regards,
joecoolvette


http://en.wikipedia.org/wiki/Decibel

you have to factory reset then use your phone and you have to go service center

How far away is your other antenna?

2.4 GHz signals may be attenuated by up to 0.05 dB/km (0.08 dB/mile) by torrential rain (4 inches/hr). Thick fog produces up to 0.02 dB/km (0.03 dB/mile) attenuation. At 5.8 GHz, torrential rain may produce up to 0.5 dB/km (0.8 dB/mile) attenuation, and thick fog up to 0.07 dB/km (0.11 dB/mile). Even though rain itself does not cause major propagation problems, rain will collect on the leaves of trees and will produce attenuation until it evaporates.

"F02" is a Long Drain error. If the drain time exceeds 8 minutes this error code will be displayed. In addition, a "SUDS" error may also be generated as a secondary error. This is an indication of a drain pump problem and/or clog in the drain line. You will need to check the following:

1. Check the drain hose to make sure it is not kinked or clogged.
2. Check the electrical connections to the pump and ensure the pump is running.
3. Remove the drain pump filter and check for foreign objects and/or debris.

To check the drain pump, click on the following link for step-by-step instructions.


http://www.fixya.com/support/r385844-checking_drain_pump_kenmore_elite_front

If the above procedures do not correct the problem, it is recommended by the manufacturer to replace the drain pump


Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question.