Acer x193 moniter shows no signal

This could be a result of multiple different variables. If its a CRT monitor, it could be magnetic interference that is causing it. On an LCD screen, it could be your video signal. Check the cables and make sure they are plugged in tight. Check to make sure there are no power lines or magnets around the monitor as well. Turn off any lighting in the area and see if that affects the monitor. Also you can test the monitor on a different computer to see if you get similar issues. If so, then you may need to replace the monitor or it's cable.

Hi there,
If the machine switches on fine then it means it passed the POST process. try to unplug it from the outlet and press and hold the power button for about 20 sec to drain the flea power see if that will take the computer out of hibernation. If that doesn't work you might have to reseat the memory from it's place.
I don't think there's something wrong with the screen the fact that it displays No Signal tells that the screen is active but gets no Valid signal from the tower.
Hope this helps!

i have acer veriton m264 but when i start i see nothing on moniter but cpu show that its in on position

yea your moniters fryed.

Try your monitor on another machine - if it is working you have operating system/hard drive/motherboard/memory/heating problems. You must work that out if the monitor is good.

No. Your headset must be PC connected either by audio plugs or USB or dongle adapter, depending on the hardware you have.

Your monitor is fine for voice/video messaging, just don't stick your Mic and Headphone into any thing in your monitor.

Bye

1. Check your cable
2. check your cable pins make sure there not bent.
3. Check your video card make sure its putting out the correct resolution for the monitor.

No signal is just what it is. You may have a bad cable,bent pin or video card is not operational.

Things you can try.

Hook it up to a diffrent computer
Check the pins on the cable.

Worse case would be the little board inside where the connector is could be bad.

Thanks I hope this helps

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/edwy_1a56970cf1ea4620

You may need to replace the moniter cord or check the video card on the computer.

Windows doesn't know your display is broken as it see's your display adapter for the laptop. By adding the monitor windows is adding a second display to the one you don't actually have, your icons and start bar are still on display 1
sorry

Check the coolant between the CPU and the cooler to ensure it's not simply over heated.