The base it does not work. it does not turn on. and the 2 phones only say: searching

Because they can't find the signal from the base. Unplug the main base, set the handset in the base and plug it back in. Also, make sure that the telephone line in is plugged in secure

Take the first phone off from the base and turned of.Unplug the power from the base. Put the second phone in the base. Plug in power in the base. The base must search the new " IP or code "of the second phone. Turn on now the first phone , you should hire a small beep on the base or the unit and should be OK. Both must working now. I wait for an answer.

sell me your base, mine broke but my phones seem to work. 613 912 1422 ian

Bring your mobile phone, with its bluetooth radio turned on, between 2 and 10 feet away from the 28127 base. Press and hold 'CELL 1' (if it is the first phone you are paring) or 'CELL 2' (for the second one) on the 28127 base, until the corresponding LED flashes. The base is now in pairing mode. Now, make your phone's bluetooth application search for new devices. After a while, the 28127 should appear on screen. Select it and make the application proceed. If a passkey (or PIN or pairing code) is requested, enter '0000' (four zeros). The paring process is successful when the LED gets lit, indicating that it is connected to your phone. To disconnect, press and hold 'CELL 1' (or 'CELL 2), until the LED is turned off. To reconnect it to your phone, briefly press 'CELL 1' (or 'CELL 2').
By the way, just in case you happen to be miss your cordless phone's user manual, feel free to download it from this location.
Hope you are able to sort your problems out.
Cheers! Carlos

check to see if the power cord is properly plugged in. You may have the phones on the wrong cradles, this wil cause them to search.

Reset Procedure for Cordless Phones
Question:
What is the general reset procedure for cordless phones?

Answer:
1. Disconnect Battery from handset(s)
2. Disconnect Phone Cord from wall jack
3. Disconnect Phone cord from base unit
4. Disconnect AC adapter from wall outlet
5. Allow to sit for 30 min
6. Reconnect Phone Cord to base
7. Reconnect Phone cord to wall jack
8. Reconnect AC Adapter to wall outlet
9. Reconnect Battery to hanset until you click or feel the plug snap into place
10. Re-Register Handset by placing on main base in most instances

"Base Search" will display for several reasons.

1. The base station is turned off or not working properly.
2. The handset is not registered.
3. The handset may be registered somewhere else, de-register it.
4. The units (both base and handset/s) may need to be reset to factory default.

You may have already tried this.

the same problem after it worked 3 years. any solution arround?

May be your base just doesn't support 3 phones at the same time. Try to turn off one of the working phones, reboot your base and reregister the one that you have problems with. If it works then turn on the turnedoff phone and try to register it, if the same problem appears with this one, then your base just doesn't support 3 phones at the same time.

como activar mute la pertada 2 sin vos