MHW6000XW LIST OF ERROR CODES AND WHAT THEY MEAN

According to https://www.justanswer.com/appliance/7w4q8-f01-e02-error-code-showing-whirlpool-front.html, it indicates that the controller isn't getting readings from drum tachometer. Could possibly be loose wire. Replacement parts said to be $200, so may not be worth buying.

you might be able to sell to someone willing to diagnose & fix.

Whirlpool breadmaker e02 error Questions & Answers - Fixya

www.fixya.com > Forum > Tags > breadmaker e02 error
Ask your Whirlpool breadmaker e02 error questions. Get free ... I am getting F01 andE02 flashing errors and the machine will not go into spin cycle . How bad is ...

Replace the motor control board. The machine cannot tell the speed any longer. These boards are expensive and even much more time consuming to think you can repair the board. Call your local parts place and ask them if they can have the board tested, if you want to .

Found this on another site. It is the Service Manual Link

http://www.applianceblog.com/mainforums/attachment.php?s=001fc13abc99c02a4aa812a23c01ac7e&attachmentid=13030&d=1381289434

Hope this helps

1. Disconnect power for at least 30 seconds.
2. Re-apply power and observe for at least one minute.
3. If code re-appears, replace control board (also called ERC or clock).

Read more: http://www.appliancepartspros.com/repair-help/whirlpool-fault-codes.html#ixzz3PsUurTNH
http://www.appliancepartspros.com

f06 OR e02 error code means you have an interface communication error. the main control board isn't communicating with the front interface control board. if you pull the washer out and remove the 3 screws coming in from the back of the top panel. the top panel will pull straight back, up, and off. check all the wire connections between the two control board and make sure they are all secure. if everything looks good, then the interface control board may need to be replaced.
f01 e02 means that your motor control board is not reading the tachometer on your motor when it tries to turn the motor. it thinks that the motor is struggling. open the door and turn the basket to make sure it spins freely.

Here is the manual. Hope it helps: http://www.applianceblog.com/mainforums/attachment.php?s=001fc13abc99c02a4aa812a23c01ac7e&attachmentid=13030&d=1381289434

DFDFDFDS

For how long did you unplug the power cord? If it was under 5 minutes, unplug it for longer. Check if that clears the error code. If it doesn't, the motor control unit needs to be replaced.

Please double check your model number to get the correct part. Most of the Whirlpool washers have model numbers that start with 3 letters.

I hope this helps.

Cindy Wells