Beko built in double oven alarm after power outage
Had a power outage and when the power came back on the alarm on the oven sounded. The display is also flashing but I am unable to reset anything as none of the functions work. I have tried turning it off at the mains but that makes no difference. The only way to silence the alarm is to switch it off at the mains. Can anyone help please?
Re: beko built in double oven alarm after power outage
Switch oven on using the function knob (first knob on left hand side)then press and hold(for 3 to 5 seconds) the left top button right next to the display screen this should give you a chance to set the current time on the oven after setting the current time switch oven off at function knob and on agian problem should be solved
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Does the rest of the oven work ok? Did the timer work OK before the outage? Is the oven under warranty? Was the power outage at your home only? Check with the manual to see if it addresses your problem, there may be a way to reset the system and then I would say that you would need to contact Westinghouse and explain the situation.
I would suggest set unit in self clean then cancel, this should rotate the lock and reset the lock position for you, apparently the unit was in a cycle when the power issue accrued and is unable to reset on its own. Try this and see if this corrects this issue for you.
I had a Wolf 30F wall oven with a similar problem after power outage. It wouldnt stop beeping with error message related to temperature control. My solution was to turn power of at circuit panel, then reset by pressing and holding the clear button for 5 seconds.
Also note: in my case I had to close the display before switching the panel off. When I tried to the reset process with the panel showing, it wouldn\'t reset.
To reset other various parts of the control panel Instructions said:
Immediately after the oven is installed, set the 12-hour clock to the current time of day. It may need to be reset after a prolonged power failure. The clock is visible on the control panel during all modes. If the upper oven timer is set, the clock will not be visible in the upper oven control panel display.
1) Touch CLOCK.
2) Touch number pads to set current time of day.
3) Touch CLOCK or ENTER to start clock.
The time-of-day clock can be changed from a 12-hour clock to a 24-hour clock. After the clock has been set, touch TEMPERATURE for three seconds, touch CLOCK, and then touch ENTER. Follow the same sequence to change back to the standard 12-hour clock setting.
Fahrenheit to Celsius
The oven can be changed from Fahrenheit (°F) temperature to Celsius (°C).
Hello, the F1 error code means internal logic failure (monitoring function) it sounds alarm and inhibit cook mode You can fix it by replacing the electronic range control (ERC)
F7 error code means the function key shorted for over 16 seconds, check for something pressing a key or preventing normal release of the key. You can fix it by replacing the electronic range control (ERC) if other component check normal.
Unplug the cord behind the oven. You'll need to pull out the oven a bit. Not too far as the flexable gas line is there also. Wait 10 min and replug the oven. This will reset the curcuit board after the power surge.
You unit is stuck in the "Display Model Mode". Hold the stop/clear button for at lest five seconds in insure the interlock activates. If it does not activate then the electronic range control (erc) is not functioning. Replace the erc (Clock/Display.)