My pc doesnt reconize the belkin easy tranfer cable?

well you can fix such kind of problems via contacting to belkin tech support. for more help you may visit: Belkin Tech Support Helpline

When there is limited connectivity check if the laptop gets an IP address from the router. ELse try configuring it manually. Restart the laptop if necessary.

Please rate if helpful.

Thanks

Check the easy transfer details on the link below:

http://techtake.net/2009/08/12/windows-easy-transfer-windows-7/

http://techtake.net/2009/08/12/can-i-upgrade-from-windows-xp-to-windows-7/

This may not be a direct solution, but will help you identify the problem.

I hope this helps.

Does your router have one LED lamp for each "wired" port?
If so, does unplugging the Ethernet-cable (the one that connects to your desktop PC) cause the lamp to go off?
Does reconnecting that cable cause the lamp to go on?

Also, on your desktop computer, there could be a lamp right beside where the Ethernet-cable connects into your computer.
Again, disconnect the cable, and reconnect the cable, to see if that lamp goes off/on.

Have you tried a different cable?

Do *NOT* connect your desktop computer to the 'WAN' port on the router -- connect it to any of the "LAN" ports.

Well you can try to contact to belkin tech support and ask for online assitance hope they will fix your problem and you will be good to go.

use the Files and Settings Transfer Wizard instead of the Belkin software. It's pretty straight forward in the steps for moving files to "new" computer.

hello!

-- who is your internet service provider
-- what is the operating system of your computer?
-- is this working fine before or is this a brand new router

you may try this and see if this help solve your problem. make sure your computer is directly connected to the router

Step 1: Shutdown the computer.
Step 2: reset the router while power on then Unplug the router’s power cable.
Step 3: Unplug the Broadband modem’s power cable and wait for 30 seconds.
Step 4: Plug in the Broadband modem’s power cable and wait for its lights to appear stable.
Step 5: Plug in the router's power cable once the modem’s lights appear stable.
Step 6: Power on the computer on and configure the router settings
Step 7: test the Internet connection.

if this still didnot work, upgrade the firmware of your router

note:

configuring the router settings will depends who is your provider. if your isp is dsl you need to configure your ISP username and password on the router. if your router is a cable no need to change any settings on the router. it should automatically work

if you are still having trouble configuring your device, call supportrix and use supportcall as your promo code for 1 free technical support.

the red light means u havent got a connection if u have installed properly try upgrading the firmware the problem might be the routers
http://www.belkin.com/support/product/?lid=en&pid=F5D9230-4&scid=221