Wy is my GFCI triping without interference? - Leviton 8299 Combination Switch / Smart lock GFCI Outlet

If your ROKU keeps loading it is probably because your internet speed is too slow or your router is too slow.You might be getting interference from a neighbors router.Try getting a dual band router.

The light and fan are not properly grounded.

reset the GFCI and they will all work. The other two are down stream from the gfci.

You should not have multiple GFCI devices in any one circuit. Change out the outlet and label it
GFCI Protected if necessary...Your problem of nuisance trips should go away.

John

Refrigerators should not be run on gfci plugs .As they age , they will pull slightly more amps . Also , gfci plugs will weaken even though no previous problem with them . If you have a gfci plug behind the refrig , replace it with a normal type plug .

I think this is normal for a GFCI.

Amperage pull too high. Increase the rating of the GFCI outlet - or there i an issue with the washer itself.

Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question

Ground fault should not be used when you have a compressor plugged to it. The start amps can trip a ground fault. You can try to plug the unit on a regular outlet and if it doesnt trip the breaker then unit should be good. You can try to replace the ground fault if you need it (but make sure you have a higher amperage on the new one.)

You more than likely have a dead short in the compressor