Question about Regal Ware K6725 Kitchen Pro Bread Maker
Belt is worn. There must be a replacement out there some place
Hi, I have the same machine and the belt was in tiny rotten pieces...I wound a piece of yarn around the wheel and drive shaft (lie the machine on a kitchen counter, lid open and hanging down off of the counter, bottoms up, and remove the screws from the teardrop shaped brass colored safety cover, remove the cover and expose the wheel and drive shaft) pull the yarn tight and knot it. Then cut the yarn about an inch from the knot. Measure the yarn when pulled on a little. Mine measured 23.5"....I then googled bread machine belt 23.5" and up came one for an Oster Bread Machine (The one I was repairing was a Regal Kitchen Pro 6725) from totalvac.com located at 2 De Bush Ave Unit A8 Middleton, MA 01949
It was $7.95 for the belt, $6.95 S & H to a VA address, total cost $14.90 so I decided to give it a shot. When it got here, I removed the safety cover, held the machine up and shook as much of the old rotten rubber belt pieces out as I could, and replaced the belt by placing it over the sticky string on the drive shaft and teasing it over the wheel. It is an exact fit. Be sure the ribbed side of the belt is down against the wheel. Screw the cover back on and run it through a dough cycle so that the belt will get coated with the sticky stuff from the sticky string on the drive shaft. Until the belt is coated, it will turn the mixing blade, but it will slip. Hope this helps. Patti
Posted on Sep 13, 2009
Where can i buy a drive belt for a k6725 bread machine?
Posted on Feb 14, 2009
Try this site, they have the belt and other parts as well.
Posted on Dec 15, 2010
There is an Ebay store that sells replacement parts...
They might have something close to the correct size belt needed for k6725.
What a pain in the rear hey?
Posted on Nov 29, 2008
I had a Regal K6725 and loved it. Dropped a frozen strawberry in it yesterday, and pop, the prop snapped off. Hence, I have a perfectly operable Regal K6725 bread machine, and manual. If anyone wants either, email me with a proposal of how I can ship it to you. My address is: [email protected]. The pan is perfectly fine too, but I have not been able to pull the prop off for washing. I just kept it in there all the time, and used a toothpick or knife to clean out the crevices. If someone needs the pan with a knocked-off prop stuck in it, I have that too. It is such a waste just to throw this stuff in the dump, when the only thing wrong with it is a bad prop. I checked ebay for the pan, and they want about 40 bucks for it after shipping, and around 25 for the prop.
Posted on Apr 29, 2008
Tips for a great answer:
Usually answered in minutes!
Step 2: Please assign your manual to a product: