B&S one start pull take numerous pull to start

Try 1/2 choke and part throttle with trigger, after several pumps of the primmer bulb.....You have to allow some air to the engine when creating a rich start condition.........

If its identical it should work ,if not take the old one to a mower shop,to get correct one and make sure the choke is going right on when the cable is in choke position.

after trying to start it a bunch of times, take spark plug out and see if it's wet with gas.

All mowers start with throttle High and with the choke on OR if it has a primer bulb, you have to prime it until you see gas in the bulb

acid dip rebuild carb make sure fuel selinoid on bottom of carb moves freely

I believe that your question is in reference to the primer button on your carburator. If this is so and your button is pushed in then you will have to change the button. Take a pair of needlenose pliers and pull out the damaged primer bulb. Then go in with a pick tool and pull out the ring that is seated in the carburator at the bottom of the primer bulb. With the old primer bulb out of the carburator you can now install the new primer bulb. Put new primer bulb into place and with a dull punch slowly and very carefully seat the new primer bulb. This should put you back in business again. GOOD LUCK.

The procedure for starting an engine is as follows:

• Check that you have the throttle in the start position and/or on high revs with choke on
  
• Prime the engine by pushing the button about 5 times
• Pull out the cord until you meet resistance. Then let the cord go fully back into the engine and then pull the cord out sharply. Repeat this until the engine starts but not more than a few times.
• If the engine doesn't start, try pressing the primer button another few times then try to pull start the engine
• If the engine doesn't start after a few pulls it may have flooded so leave it for a few minutes before pulling the starter rope
  

This Power washer has a 3.75 hp Briggs and Stratton Engine. It does not have a choke but does have a primer bulb. You must depress the primer bulb at least 3 times to start the engine. The primer bulb is on the side of the carb. It can be black or red. If your still unable to locate the primer bulb please provide your ENGINE model number and I will provide you a link to a diagram for the location of the primer bulb.

Thanks for using FixYa.

Kelly

pull the bulb and retaing ring any way you can. don't try ti save them. you get a new retaing ring with the bulb. put the new bulb in then work the retaing ring in with a screw driver,clean everything behind the bulb before you put the new on in.

pull the cap off and look there,it is probably covering an adjustment screw for carb.