Why does my washing machine unlock itself in mid-cycle?

NOT SURE BUT SEEMS LIKE MAYBE UR MOTOR COUPLER MAY BE GOING OUT

Your Circuit Control Board is starting to Fail.... The Electrical Reset is the give away....

Lid Switch Assembly

If the washer stops mid cycle the lid switch assembly might be defective. This is a very common problem. The lid switch assembly can fail either mechanically or electrically. Test any electrical switches with an Ohm meter for continuity. The switches should have continuity according to their design.


Enter your model number to see parts for your washing machine.
Help me find my model number

Door Lock Motor and Switch Assembly

If the washer stops mid cycle the door lock assembly should be checked. The door lock can fail either mechanically or electrically. Test any switches on the door lock with an Ohm meter. The switches should have continuity according to their design.


Enter your model number to see parts for your washing machine.
Help me find my model number

Water Inlet Valve

If the washer stops mid cycle the water inlet valve cold water side may have failed. Most washers have a cold water rinse and so if they can't fill with cold water they just sit indefinitely waiting for the cold water to enter. If there is cold water to the water inlet valve and the cold water works in other parts of the cycle - or to make warm water - the valve is not the problem.


Enter your model number to see parts for your washing machine.
Help me find my model number

Main Control Board

If the washer stops mid-cycle the main control board might be defective. This is not common. Check other causes first such as the lid or door switch and other components.


Enter your model number to see parts for your washing machine.
Help me find my model number

Timer

If the washer stops mid cycle the timer might be defective. This part is often misdiagnosed, check other components before replacing this timer.

God bless you

The washer timing control is defective.

This has happened to me when the power has gone out. It doesn't display anything and all you can do is restart the cycle.

Hi,
When you are putting the heavy clothes (towels robes) the sleeves of the towels will come out easily and get stuck in between the drain out valve so it will not sent the water out properly please avoid heavy clothes(towels robes) try to give a normal load

add a pail of water if it starts adjust level control

the timer change by itself. You don't have to change anything.
But cold rinse only works if you have the cold water connect to the washer

you need to replace the timer it is faulty let me know how you make out

-Sounds like the timer is out. Check it out and replace it

Good luck
Mai