Water leaks from the bottom door

"F2 - A water leak, which if detected will stop water from entering the dishwasher via the inlet valve. You will probably experience the dishwasher not filling properly during a cycle. Possibly caused by a faulty water level indicator, you can also try cleaning the filters and drain if you notice a lot of standing water remaining in the dishwasher basin."

"Look in the bottom of the unit. Something has it stuck, like food."

sorry if this doens't solve your problem. This is what turned up with your keywords in a quick search engine query.

Push the little lever sticking out of the dispenser.
Maybe you have some calcium or hardened soap that is holding the lid closed. some Lemi-Shine powder dissolved in hot water and use an old toothbrush to clean off the soap/hard-water deposits.

If you need further help, reach me via phone at https://www.6ya.com/expert/ronald_e6b9572cebe3ad27

You electic water valve is sticking open, they get sand etc in there, and can not close, and will not shut the water input off. Do you have city water, or your own well water? Very common problem with well water, sand will clog the return of the water valve from shuttin off the water. Easy to check if you can shut the power off, and water off. dis-assemble the water inlet valve( first thing the input warter goes to)

Happened on my dish washer too. Remove lower rack, remove lower spray arm by removing the center plastic nut, check screws (torx) on outside edge of pump. Tighten these as necessary, mine were loose causing water to spray forward against the tub causing leakage.

Without knowing the model number of this Sears Kenmore dishwasher, it is difficult to be specific in a solution.
There is a float/switch that controls the amount of water added before each wash or rinse cycle. Replacing that float would be the first step.
Can not be more specific without knowing the model number.

when you hear the motor running during the wash cycle, check to see if the washer is actually draining instead of washing. this would indicate a stuck open drain valve. (the same motor/pump that washes the dishes, also drains the unit)

lreplace the pipes or hoes

I have a kenmore ultra wash II Model #1675590 Serial # FC1024731

Will not run and water is standing in the bottom. I have checked the electrical breaker and tried different cycles. Can you help.

check your curcit board, could take care of the problem

Got a possible solution from a brilliant guy named Jake on another website and thought I would post it back here.

"Check the door vent on the inner side of the door, that should just snap out, I have seen those clog and start making more pressure inside to make it leak from the bottom. Jake"

I checked mine and got a nasty surprise. Who knew it could get so dirty.