Question about Pioneer VSX-07TX Receiver

1 Answer

Pioneer vsx-07tx-blows fuses immediately

Hello,switched from dvd to ld/sat blew fuses on 2 amps other rotel ra 1060,installed new fuses same result,both dead.

Posted by Full Auto on

  • Anonymous Mar 29, 2014

    The source selector on Rotel RA-1060 amp IS STUCK ON TUNER AFTER STATIC ELECTRICITY. I checked the 4 visable fuses in the unit and they checked out ok. I also powered the unit down & unplugged it for an hour. The source selector turns to each source, but the light stays lit on tuner and no other source can be heard. The knob can keep clicking around the sources including after the sources. I don't remember it doing that before.

×

Ad

1 Answer

Anonymous

Put 20a fuse in.

Posted on Dec 29, 2007

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a rotel amp model no is ra-313


I'm guessing you don't know for sure that it even needs fuses. They don't go out like they used to, as everything is controlled by a microprocessor(computer within your unit). I would suggest, that you, with the power plug pulled out, use an ohm meter to be sure that each fuse is shorted. If you need further assistance, or would like to inquire about a repair, please visit my website at audioserviceclinic.com. Thank you.

Jul 30, 2014 | Rotel Audio Players & Recorders

3 Answers

Spilled water on Rotel RA-1060 is now overheating and switching off/on


there must be virtual contacts between connection on the main board

Jun 10, 2008 | Audio Players & Recorders

1 Answer

Fuse for rotel amp for RB-870BX


IF THE FUSE YOU ARE PLACING IS THE SAME TYPE AS THE ORIGINAL YOUR AMP HAS A PROBLEM WHAT YOU MUST DO IS TO SLIGHTY INCREASE FUSE BY 100 MAMPS PER TIME IF IT IS IN THE TRANSFORMER CIRCUIT YOU CAN INCRESE IT BY 2 AMP MAX IF IT IS IN THE MOSFETS CIRCUIT YOU CAN INCRESE IT BY A MAXIMUM OF 500MAMP LET ME KNOW THE RESULTS

Mar 04, 2012 | Rotel Audio Players & Recorders

2 Answers

JD-VD502 DVD player blew a fuse. I replaced it with a 1-amp 250 volt from radio shack but as soon as I powered on, the fuse flashed and blew again. I tried twice, same result. Is there a reason this keeps...


Hello
Never put any fuse in it and switch ON. It has some short with internal circuit, and should be repaired before installing a new fuse. The fuse use is as a protection device to protect the other circuit parts from further damage. If you will put an other fuse, and switch it ON again, you are making things more worse than present. Find out the reason for buring out fuse. If you can do it by yourself. Otherwise get it repaired by any experienced service personal. Never make it irreparable. OK.

May 07, 2011 | Jwin JD-VD502 DVD Player

1 Answer

My Rotel RA-935BX blows out the fuse on the power socket during operation, after repair the fuse, it is blow out as Rotel power on, what's wrong?


It seems you have a short circuit in your unit. Further attempts at switching it on are not advisable as more damage will occur. Get it checked out by an electrician who can test from the plug for a short circuit.

Apr 09, 2010 | Audio Players & Recorders

1 Answer

The two 5 amp fuse inside the amplifier keeps blowing


Hi,

That must be the inrush current.
Maybe you are using the wrong fuses.
Please check if those are fast or slow types.
You need slow types.

Good luck,
Gerard

Jan 17, 2010 | Audio Players & Recorders

1 Answer

Where can Ibuy 2 capacitors for my rotel RA-840b?


Depends where you live! If in the UK you can get capacitors from Maplin Electronics. If you are in the US then the best place is Radio Shack I have been told.
Sometimes the website of the maker of electronics piece will have the authorized parts dealer address etc on the website.
Are you certain they are the only parts that have failed? I had an amp in for repair that blew them, but it was the main IC amp that was causing them to blow.

Jul 02, 2009 | Audio Players & Recorders

1 Answer

Need manual for ra 840bx4 & wattage output when remote speakers?


Lets try the simple stuff first. This whole problem could be caused by a dirty switch contact. Pick up some electronics cleaner from a local electronics shop and spray the switch (from the inside of the unit). Work the switch on/off a number of times then respray one more time. That should clean out any dirt that is there. Try the unit again and hopefully the problem is resolved. If not, then the switch itself may need to be replaced. When you get the cleaner, get one that contains a lubricant as well. This will help to prevent the problem from coming back again.

Dan

Jun 20, 2009 | Rotel Audio Players & Recorders

1 Answer

Problem with Rotel RA 870


Since it is a Rotel, it is a good unit and worth fixing. At this point, you need to take it to a good repair shop and let a qualified tech look at it. There are no user serviceable parts inside and if you go poking around in there, you WILL make the problem worse. Rotels' are nice units and represent a good value in stereo gear. Take it to a reputable repair shop that repairs Rotel under warranty. If thats not available to you, then a good repair shop should be able to get you going. Good luck...Rob

May 09, 2008 | Audio Players & Recorders

Not finding what you are looking for?
Audio Players & Recorders Logo

Related Topics:

294 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pioneer Audio Players & Recorders Experts

 Grubhead
Grubhead

Level 3 Expert

5700 Answers

ThaMp3Doctor
ThaMp3Doctor

Level 3 Expert

8597 Answers

The Knight
The Knight

Level 3 Expert

76407 Answers

Are you a Pioneer Audio Player and Recorder Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...