Unabel to print 72

https://www.manualslib.com/manual/794794/Brother-Dcp-7055.html?page=81

https://www.manualslib.com/manual/794794/Brother-Dcp-7055.html?page=106

Brother DCP 7055 Service Manual Error Code Ee ef

Quoting from the free manual Page 2-69:

? Error code EF
Print Unable EF
Turn the power off and then back on again.
The supplied power is unstable.
Step
The irregular power supply is
detected
1
2
Main PCB failure
Note:
• The irregular power supply detection error (Machine Error EF) occurs when there is a
large fluctuation in the power supply voltage supplied to the machine.
In this case, if the same power supply is used, the same error might occur again even if
the low voltage power supply PCB ASSY is replaced.

Try this website: Brother DCP 7055 Drum Unit Reset Instructions

FAQs Troubleshooting DCP 7055 Others Brother

http://support.brother.com/g/b/faqtop.aspx?c=eu_ot&lang=en&prod=dcp7055_all




DCP 7055 Others Brother Solutions Center




http://support.brother.com/g/b/producttop.aspx?c=eu_ot&lang=en&prod=dcp7055_all


see above links for possible resolutions

Page Settings may have a box checked "Shrink To Fit" if so un-check.

How solution Unebal to EF in Brother DCP 7055 matchine ?

PRint unable EF

I have brother DCP 7055 it shows print unable 72 & some time it show 71 error pls suggest

This came from the Brother HelpDesk, yes they rang me and it worked.
Cover open Press Clear "Replace Drum?" (ignore this and quickly...) Press Start (blank screen, quickly...) Press Up arrows then switch to down arrow to 00 Press OK

brother dcp 7055 error-EF laser