Login with password is not working

To make sure that the usb flash drive is working, try inserting it in a different computer. If the problem persists, you may have a defective usb flash drive. Try returning it back to the store where you bought it from to avail of the product warranty. If the store where you buy it is legit, they should replace your item with a working one. To avoid this problem in the future, try using it in the store first before taking it home.

Cruzer Program Wizard wont work. Then says there is no internet connection.

Hi,

You can download the driver for Cruzer micro from below website

http://www.sandisk.com/sandisk-support/driver-download-wizard

Thanx

Hello Niz: If the stick is still usuable try downloading launch pad this usually works if the memory chip is still viable, You can get the download wizard from this site.
http://www.sandisk.com/sandisk-support/driver-download-wizard

If your cruzer came with U3 then you are in luck. U3 can be set with a password that requires login before any data can be accessed. Just be sure you don't forget the password because it will have to be erased to reset it.
It can be downloaded from here.

sounds like the usb ports on your computer are going dead.. You may have to use your drive on another computer to retreave data then put it on cd..

1. Download this tool:
http://dl.dropbox.com/u/4040651/LLFTOOL.EXE

2. Format

(WARNING: After running this low level format tool,
the whole USB flash disk surface will be fully erased.
Therefore, data restoration will be impossible after using this utility!)

PASSWORD

did you get a disk with it? i think i did when i bought mine!!!

Reboot system