Because it is new and machine is new too.please tell me the procedure to run it in manual/hand mode. i have combivert software and i uploaded the drive parameters to my PC. Please advice. we tried to run in manual mode, by doing CP0=500, but display is showing LS and even after pressing start Drive is not running.
SOURCE: F5 KEB inverter nop problem
If using bus communications (Can, ProFi, Mod, ext), there may be a communications command (Software signal) that is not being provided. Hardware and software enable signal required to obtain LS.
Possible that the terminal on the control card is bad due to miss connection or signals outside of the rated value.
854 views
Usually answered in minutes!
×